Xenith BACK PLATE Assembly Instructions

BACK PLATE
FRONT
BACK PLATE
ASSEMBLY INSTRUCTIONS: XENITH SHOULDER PADS
Hardware Contents
2 Attachment Straps
2 Elastic Hardware Covers
4 T-Nuts
4 Screws
Step 2
Place elastic hardware cover onto attach-
ment strap.
Step 4
Feed upper end of attachment strap back
through elastic hardware cover
Step 6
Install screw through front of grommet holes
into t-nut and tighten.
Step 1
Feed lower end of attachment strap with
two grommets through slot in back plate
from outside to inside. Select inner or outer
slot to best match up with slots in
shoulder pad.
Step 3
Feed upper end of attachment strap
through slot in shoulder pad from outside
to inside.
Step 5
Align the two grommet holes on the lower
end of the attachment strap with one of
the grommet holes from the upper end, and
place a t-nut through the three grommet
holes from back to front. The vertical
position of the pad can be adjusted using
the di erent grommet holes.

STEP 7

Slide elastic hardware cover over t-nut and
screw. Repeat process from step 1 for
other attachment strap location.