Advertisement
Table of Contents
- 1 Items Included
- 2 Remove the Base and Casters from the Packaging
- 3 Remove the Pole from the Packaging
- 4 Remove the Anesthesia Machine Head from the Packaging
- 5 Fill Absorber Canister with CO2 Absorbent
- 6 Check Inhalation/Exhalation Flutter Disks
- 7 Cut the Cable Tie Securing the Vaporizer Endcaps
- 8 To Download a Full Operations Manual for this Machine
- Download this manual
Items included:
Page 1 of 2
Rev. 3
Versa II Anesthesia System
Quick-Start Guide – Pole Mount Option
(if installing as a tabletop unit go to
download the quick-start guide for tabletop option.)
Base and casters
Machine pole
Anesthesia machine head
Hardware bag (contents documented by label on bag)
Remove the base and casters from the packaging and place
on the floor.
Remove the pole from the packaging. Place the pole into the
base (tapered end into base). Tap firmly to seat pole into
base.
Customer Service: 1-800-225-7911
www.pattersonscientific.com/manuals
Universal F Circuit
MJR Circuit
Absorber canister (boxed)
Remove the anesthesia machine
head from the packaging and
place the mounting "spud" into
the top of the pole.
Align the hole in the "spud" with
the hole in the top of the pole.
Insert and tighten using the pole
knob found in the hardware bag.
Tech Support: 1-866-825-6076
and
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Patterson Versa II
Summary of Contents for Patterson Versa II
- Page 1 Versa II Anesthesia System Quick-Start Guide – Pole Mount Option (if installing as a tabletop unit go to www.pattersonscientific.com/manuals download the quick-start guide for tabletop option.) Base and casters Universal F Circuit Machine pole MJR Circuit Items included: Anesthesia machine head...
- Page 2 (with Patterson logo facing the front of the anesthesia machine) with the knob from the hardware bag. Make sure the divider in the absorber canister lines up with and goes into the slot on the bottom of the absorber block so it seals against the gasket before fully tightening the knob.
Need help?
Do you have a question about the Versa II and is the answer not in the manual?
Questions and answers