Advertisement
Feed Leg. Whilst supporting the Feed Leg rotate the Clamp down over the Leg ensuring
that the location lugs on the Clamp lock securely into place in the cut outs on the bottom
of the Feed Leg.
3. Using a current digital satellite meter align the antenna to the Sky satellites using the approved
procedure. Ensure the antenna face is kept horizontal using the spirit level on the Feed Clamp
assembly, remembering to tighten the two rotation bracket bolts mentioned in Section 2
of the assembly Instructions above.
Note that the spirit level bubble can be viewed from either above or below.
4. Before finalising the installation re-check that the dish face is perfectly level, the LNB is at the
correct skew setting and that signals are optimised. Ensure that all bolts are tightened whilst
maintaining signal optimisation but avoid over tightening as distortion of the dish face or support
assembly will dramatically lower the performance of the dish.
Check that the LNB skew setting is appropriate to
5.
the area. To adjust where necessary loosen the
clamp screw and reset to the correct position before
retightening. Angle the front edge of the LNB
Clamp so it locates under the return on top of the
6. Remove the mounting button from the Feed
Clamp and push this through the hole on
the top surface of the clamp through into
the feed leg, ensuring that the button sits
firmly on top of the Feed Clamp.
ALIGNMENT PROCEDURE
1. To mount the Antenna to the wall place the Wall Mount
Bracket against the wall at the desired site. Ensure the
rectangular holes are at the bottom and the square holes
at the top. Using a spirit level to ensure the bracket is
perfectly level.
2. Mark and drill holes in the prescribed way and fix the
bracket to the wall using 4 x M8 coach screws and nylon
using 2 x M6 x 16mm bolts and 2 x M6 Serrated flange nuts.
plugs. Attach the Swing Arm to the bracket and secure in place
Advertisement
