Stand Removal / Wall Mounting; Getting Started; Remote Control Battery Installation; Antenna Connections For Off-Air Or Cable - Sanyo DP55360 Owner's Manual

STAND REMOVAL AND WALL
MOUNTING
(OPTIONAL)
Tools Needed: Phillips screwdriver
IMPORTANT NOTE: Place HDTV face down
on a padded or cushioned flat surface to
protect the screen and finish.
Wall mounting of the HDTV must be performed
by a skilled person.
1 Remove the two (2) screws holding the stand
base cover and carefully dislodge.
2 Remove the four (4) screws securing the
stand base to the HDTV. CAUTION: Hold the
stand firmly as you remove the last screw.
3 Use the screws that are threaded into the four
(4) inserts on the back of your HDTV to secure
it to an appropriate wall mounting kit.
VESA standard interface: 400 x 400
Mounting screws measurements:
M6 (6mm) Diameter, Length—12mm (maximum)
NOTE: Wall mounting kit is not included.

GETTING STARTED

BATTERY INSTALLATION
Install two (2) "AAA" batteries in the remote
control. (Not included)
To ensure safe operation, please observe the
following precautions:
• Replace both batteries at the same time. Do not use a
new battery with a used battery.
• There's a risk of explosion if a battery is replaced by
an incorrect type.
• Do not expose the Remote Control unit to moisture
or heat.
• Be sure to match the "+" and "
batteries with marks inside the remote control.
ANTENNA CONNECTION FOR
OFF-AIR SIGNALS OR CABLE
Hook up your antenna or your cable service to
the HDTV's ANT terminal with the use of a 75
OHM coaxial cable.
NOTE: Keep your indoor antenna at least 3 ft. away
from the television set and any other electronic
equipment.
ANTENNA
CABLE
The tuner in this HDTV can receive:
• Digital and Analog off air signals from an antenna
• Analog or ClearQAM cable channels from a direct
Cable TV connection.
www.sanyoctv.com
Need help?
–
" signs on the
ANALOG / DIGITAL
ANTENNA IN
5
1-877-864-9604