#3160 INSTALLATION INSTRUCTIONS < 3 mm For mounting on Metz™ and Shakespeare™ ® Squatty Body antennas. For use with whip antennas only. Antenna diameter must be less than 1/8" (3 mm). Adjust reference tabs. Bend the tab support wire to the proper angle using the reference tab template included in the packaging and reproduced here at half size.
Page 2
Remove whip from antenna body. Metz Loosen lock nut so that whip may be removed from antenna body. If you must unthread the nut all the way, be careful not to lose the tiny compression ferrule inside (see drawing). Shakespeare Models with removable whip…...
Page 3
Slide Windex AV vane components onto whip. Install in the order shown: If you removed the whip, reinsert it into the antenna body. Tighten lock nut or set screw. Slide vinyl keeper down so vane is held in place yet turns freely. Final assembly.
Page 4
Final assembly. ® Shakespeare Squatty Body antenna: Refer to the drawing at right. • Disconnect antenna cable. • Remove lock nut. • Slide reference tab support wire over the coupler. • Place stainless steel washer onto coupler. • Slide coupler into Shakespeare bracket. •...
Replacement Parts Contact your dealer or Davis Instruments to order replacement parts. 3161 Spare Vane (w.o. hardware) R3160A Stainless Reference Arm with Tabs R3160B Vane Hardware (2 teflon washers, vane keeper, stainless washer) 3160_Eng.pdf October 2005...