One (1) year from the date of installation by the original purchaser (“Warranty”). If such a defect is determined by Chore-Time to exist within the applicable period, Chore-Time will, at its option, (a) repair the Product or Component Part free of charge, F.O.B. the factory of manufacture or (b) replace the Product or Component Part free of charge, F.O.B.
General Support Information The Chore-Time Linear Lift 800 Assembly is designed to open inlet doors. Using this equipment for any other purpose or in a way not within the operating recommendations specified in this manual will void the warranty and may cause personal injury.
Linear LiftTM 800 Assembly About This Manual About This Manual The intent of this manual is to help you in two ways. One is to follow step-by-step in the order of assembly of your product. The other way is for easy reference if you have questions in a particular area.
Safety Information Linear LiftTM 800 Assembly Safety Information Follow Safety Instructions Carefully read all safety messages in this manual and on your equipment safety signs. Follow recommended precautions and safe operating practices. Keep safety signs in good condition. Replace missing or damaged safety signs. Decal Descriptions DANGER : Rotating Parts Severe personal injury will result, if the electrical power is not disconnected, prior to...
Linear LiftTM 800 Assembly Safety Information Available Sizes and Speed of Operation • The Linear Lift 800 has a total stroke of 18". • The lifting speed is 12" per minute. • Total Weight Capacity of the Lift is 800 lbs. Cable/Pulley Combinations Same Speed (Ratio 1:1)
Linear Lift 800 (41920-18) Side Wall Installation With Spring Tension Closing Inlet Doors Linear Lift Part Item Description Number Inlet Spring (Close Doors) 41143 Tie Down Double Pulley Assembly 43272 41920-18 Linear Lift 800 (Open Doors) Curtain Cable Hand Winch 1212 Winch Mounting Assembly 1193...
Linear Lift 800 (44458-18 Chain Drive) Installation with Spring Tension Closing Inlet Doors (Chain Drive) Linear Lift Part Item Description Number Inlet Spring (Close Doors) 41143 Tie Down Double Pulley Assembly 44520* 44458-18 Chain Drive Linear Lift 800 (Open Doors) Curtain Cable Hand Winch 1212...
Grease Recommendation The LINEAR–LIFT is fully greased at the factory. However, for maximum life, Chore-Time strongly recommends greasing the Linear Lift 800 at each grease fitting monthly. For best results apply grease through grease fitting while Linear Lift is in operation to put an even coating of grease over the entire length of the Threaded Shaft.
Page 11
Linear LiftTM 800 Assembly Linear LiftTM 800 Installation Linear Lift 800 Switch Adjustment The Linear Lift 800 has adjustable stops (Set Collars) that may be moved to accommodate a variety of inlet opening lengths. A 1/8" Allen wench is required to loosen the set screw on the Set Collar (see Item 2 below).
Parts Listing and Identification *Parts listed are Standard unless otherwise marked or stated. Item Description Part No. Item Description Part No. 3/16 x 1 Square Key 2112-1 1/6 H.P. Gear Motor 28:1 Ratio 46379 "Sox" Spider Spacer 36333 Flexible Coupling 36363-3 Cotter Pin 2663...
Page 16
Page No. Description of Change Changed Switch from 6049 to 46324 33946 For additional parts and information, contact your nearest Chore-Time distributor or representative. Find your nearest distributor at: www.choretime.com/contacts Chore-Time Group, A division of CTB, Inc. PO Box 2000...
Need help?
Do you have a question about the Linear Lift 800 and is the answer not in the manual?
Questions and answers