Related Manuals for CableTronix CT-PLB-1L
Summary of Contents for CableTronix CT-PLB-1L
-
Page 1: Installation Manual
INSTALLATION MANUAL CT-PLB-1L Wall Mount for 30” to 63” Plasma or LCD Television/Monitor... -
Page 2: Package Contents
The CT-PLB-1L is a wall mount designed to support 30” to 63” LCD or Plasma televisions/monitors with a maximum weight of 165 lbs. Made of steel and in a silver finish the CT-PLB-1L has a 0° to 5° adjustable tilt. Measurements are approximately 35.66” wide and 2.96” to 18.9” high (adjustable). -
Page 3: Installation
INSTALLATION NOTE TO INSTALLER Warning: The installer of this product must verify that the mounting surface will safely support the combined weight of all attached equipment and hardware. Improper installation may cause damage or serious injury. The included hardware is for mounting on walls with wood stud or concrete / concrete block construction for a secure, stable, and reliable mounting. - Page 4 Dry Wall With Wood Studs The Wall Plate (A) MUST be mounted to two wood studs. Use a high quality stud sensor to locate two adjacent studs. It is a good idea to verify where the studs are located with an awl or thin nail shown in diagram 1-A below.
- Page 5 Mount TV Rails To The Back of Your Flat Panel TV/Monitor Make sure the TV Rails (B and C) are mounted at an equal distance from the top of the TV/monitor, and close to the center as possible as shown in diagram 2-A below. Knobs should face the outside of the television.
- Page 6 Diagram 4-A: Front View of assembled mount Diagram 4-B: Safety Bar with lock For assistance contact Cabletronix sales engineers at 1-610-429-1511. SUPPLIED PARTS...