Advertisement
1
1. Checklist
Before you start installing the PCI 10/100TX, verify that the
Package contains the following items:
—
—
—
Please notify your sales representative immediately if any of
the aforementioned items is missing or damaged.
2. Overview
PCI 10/100TX is a Fast Ethernet Board that fully complies
with all IEEE 802.3u, 10/100Base-TX standards. Three LED
indicators (LINK, ACT, FDX) on the bracket will help to
oversee the network link, board activity, and duplex status.
3. 10/100TX PCI Bus Configuration
PCI 10/100TX is auto-configured by the system BIOS.
•
When installing multiple PCI 10/100TX boards at the
•
server station, you should correctly configure the IRQ
settings of the PCI slots. Up to four PCI 10/100TX can
be installed in a PCI file server running NetWare
system. Each PCI 10/100TX's IRQ should not conflict
with other installed boards/devices.
4. Full/Half Duplex Mode, 10/100Mbps
PCI 10/100TX supports full/half duplex mode and 10/100
Mbps operation. Operation in half or full duplex mode at
either 10 or 100 Mbps speed is set by Auto-Negotiation or
LAN driver options.
capability, the remote link devices' working condition will be
auto-adjusted
operating mode.
PCI 10/100TX
Fast Ethernet Board
User's Manual
PCI 10/100TX Board
LAN Driver Diskette
This User's Manual
By employing Auto-Negotiation
to
the
highest
(GMF1439K-003)
performance
common
Advertisement
Table of Contents
Summary of Contents for Danpex ADP1100
- Page 1 PCI 10/100TX Fast Ethernet Board User’s Manual (GMF1439K-003) 1. Checklist Before you start installing the PCI 10/100TX, verify that the Package contains the following items: PCI 10/100TX Board — LAN Driver Diskette — This User’s Manual — Please notify your sales representative immediately if any of the aforementioned items is missing or damaged.
- Page 2 5. Boot ROM Installation The PCI 10/100TX Boot ROM is available from your dealer. To add the Remote Boot feature, insert the Boot ROM into socket as shown in Fig. 2. Align the notch and pins on the Boot ROM with the notch and pin receptacles on the ROM socket.
-
Page 3: Technical Specifications
6. Technical Specifications • Standard : IEEE 802.3u Fast Ethernet 100Base-TX, IEEE 802.3u Ethernet 10Base-T Connector: Shielded RJ-45 jack • Cable: Category 5 unshielded twisted-pair (UTP) wire, • max. length 100 meters (328ft) Data Transfer Mode / Speed: • PCI bus —...
Need help?
Do you have a question about the ADP1100 and is the answer not in the manual?
Questions and answers