Contents Introduction Roadhawk Vision Camera Specifications Caution Installing The Roadhawk Vision Camera: 10 Easy Install Steps... Inserting The Microsd Memory Card: Video Playback (Computer) How The System Works: How To Use The Roadhawk Vision App Explanation Of The Settings Menu: Troubleshooting/Faqs: Limited Warranty Statement:...
RoadHawk Vision is designed to be mounted to the windscreen of your vehicle 1080p and 2304x1296p 30fps Super HD mode very high quality video and to record video and audio on a constant loop. As soon as the RoadHawk Vision 160 degree wide-angle F2.0 Lens camera is powered up, it will begin recording automatically.
CAUTION • Do not drop the product as this could cause damage or malfunction and is not covered by warranty. • Do not touch the MicroSD card with wet or oily hands as this may cause malfunction due to • Do not place near magnets as this could cause the device to malfunction or operate erratically. card damage.
Note: Experiment with the camera position before using the adhesive. You can ensure possible. (in a Truck or Bus, aim the the camera is pointing at the correct angle by using the RoadHawk Vision App to see a camera slightly down) live preview from the camera.
MicroSD card used in the camera and the quality settings of the video window. The RoadHawk Vision camera can also hold 50 ‘event’ files. After 50 ‘event’ files have been created, the camera will start to erase the earliest ‘event’ files to make room for more.
/ device How to use the RoadHawk Vision App 1: Download and install the RoadHawk Vision app by going to the App Store or View Google Play store on your device and searching for “RoadHawk Vision”. all files View 2: Make sure the Wi-Fi switch on the side of the camera is in the ‘on’...
Explanation of the settings menu: Photo Changes the resolution of the photos taken by the camera. To change the settings on the RoadHawk Vision camera, connect the camera to your Resolution Higher resolution settings give higher quality photos but the mobile device and open the RoadHawk Vision App.
90% of all issues. To format the MicroSD card, connect your mobile device ‘event’ folder. to the camera using Wi-Fi. Open the RoadHawk Vision App and open the settings menu. Choose the “Format Camera” option. Doing this will erase any data you have on the card The camera There are two reasons for this to happen.
Using the highest quality settings available the RoadHawk applicable period herein“Limited Warranty”. This Limited Warranty is subjected card is only Vision can use up to 6gb of data per hour of recording. Using a to the following terms and conditions: holding a few MicroSD card with a small capacity coupled with a high quality ‘events’...
Page 11
STANDARDS OF WHERE THE DEFECT WAS THE RESULT OF THE CHANGE IN THE DESIGN OF THE PRODUCT COMPONENTS SUPPLIED BY A THIRD PARTY, 12. RoadHawk reserves the right to add, delete or amend the terms and conditions ROADHAWK WILL NOT BE LIABLE FOR ANY LOSSES OR DAMAGES OF ANY...
Page 12
RoadHawk Customer Care Centre or via the official website. 16. RoadHawk reserve the right to make changes to the software including but not limited to the way mapping data is displayed and the service used to provide this data.
Need help?
Do you have a question about the Vision and is the answer not in the manual?
Questions and answers