Summary of Contents for Warmworld DATATERM MK2
-
Page 1: Table Of Contents
2. Setting the Clock 3. Setting a Pre-set Plan 4. Modifying a Plan 5. Entering Your Own Plan 6. Over-riding Dataterm 7. Quick Guide to Programming 8. Summary of Pre-set Plans 9. Conversion Charts Warmworld UK Ltd +44 (0)117 949 8800... -
Page 2: Understanding Dataterm
1. Understanding Dataterm Dataterm uses the latest technology to bring the benefits of energy saving within the range of almost any central heating system. Saving energy means not only saving the Earth’s finite resources, but also, of course, saving money which is very important, particularly with VAT being added to fuel bills. -
Page 3: Setting The Clock
2. Setting the Clock The clock will need setting after a power failure or at summer / winter time. To set the clock press the “SELECT” button until MANUAL is highlighted. Press the “DAY” button to highlight the current day. Press the “HOUR”... - Page 4 4. Continued... Make a note of your current plan number. Make a further note of the temperatures you want to change. Write down the time and temperature settings you require, you can have upto 6 per day. Removing a Time and Temperature Setting, Press SELECT to highlight PROGRAMMING.
-
Page 5: Entering Your Own Plan
5. Entering Your Own Plan. Using the table below enter your required temperatures and times so that you have a copy for the future to make programming easier. S/P1 S/P2 S/P4 S/P6 S/P3 S/P5 Monday _ _:_ _ _ _:_ _ _ _:_ _ _ _:_ _ _ _:_ _... - Page 6 5. Continued... Press SELECT to highlight Programming as shown in the illustration opposite, You are now ready to programme Monday by using the HOUR, MINUTES and + or - buttons. Enter the time you want the desired temperature to be achieved and the temperature required using the appropriate buttons.
-
Page 7: Over-Riding Dataterm
6. Over-riding Dataterm. Dataterm once set can be left alone until you feel that you need to raise or lower the temperature or boost the hot water. There are 3 modes of operation and these are, Manual - Used in the summer to hold the heating off and run only the hot water programme. -
Page 8: Summary Of Pre-Set Plans
7. Continued... Programming Hot Water. Press “SELECT” to highlight PROGRAMMING Press “DAY” until all days are highlighted, use HOUR and MINUTES buttons to set times and + and - to set On’s and Off’s as required remembering to press “ENTER” to set each entry. Press “SELECT”... - Page 9 For instance, you may be out of the house all day and require only average temperatures when at home. Thus you would choose from group PO4, PO5 or PO6. If for instance you tend to stay up later in the evening and leave the house a little later in the morning then you would choose programme PO6 as it most closely matches your needs.
-
Page 10: Conversion Charts
9. Conversion Charts Time Temperature www.warmworld.co.uk...