Pearpoint SPX P356 Deployment And Operation Manual

Heavy object: care must be taken when lifting
Elevator Hook (6)
Do not use to
deploy P356 Cradle
Assembly
P356 Cradle (1)
Deploy Bracket (5)
For rope, to deploy
the P356 Cradle
assembly
P356 Cradle Deployment and Operation Guide
Step 1: Install P356 Crawler into P356 Cradle
Place P356 Crawler (3) in P356 Cradle (1). Choose whether the Deploy Bracket (5) is to face forwards or
backwards, set by whether the camera is to point upwards or downwards during deployment.
Push P356 Crawler to the opposite side of P356 Cradle from Lobe screw (4) and fully engage drives on that
side. Tighten Lobe screw until hand tight. The spring-loaded drive shafts of P356 Cradle engage
automatically when P356 Cradle Assembly is driven.
Step 2: Deploy P356 Cradle Assembly
Using a rope through Deploy Bracket, lower the P356 Assembly into position using P350 Cable (2) to guide
the Assembly if required. When it is in position, remove the rope. Set the wheel size to 170mm in the P350
'Setup Equipment' menu and begin your survey.
Step 3: After the survey
Lift P356 Cradle Assembly using a rope through Deploy Bracket. Again, P350 Cable may be used to guide
its position. Loosen Lobe screw to remove P356 Crawler from P356 Cradle, if required.
Specifications
Dimensions (H x W x L)
Weight
Dimensions (H)
Weight
Ordering information
Description
P356 Cradle
Wheel for P356 Cradle
369 x 534 x 712mm / 14.5 x 21.0 x 28.1"
22kg / 48.5lb
524mm / 20.6"
50kg / 110lb
Sales Part Number
10/P356-CRADLE
10/P356-CRADLE-WHEEL
Notes
P356 Cradle only
Min height of Assembly, incl. P356 Crawler, Powered
Elevator (lowered), PTZ Camera and Lighthead
P356 Crawler and other parts available separately
Single spare wheel 13"/325mm
P350 Cable (2)
Can be used to guide
the P356 Cradle during
deployment
P356 Crawler (3)
With Powered Elevator,
PTZ camera, and
Lighthead
Lobe screw (4)
To fix the P356 Crawler
in place in the Cradle