ThermoWorks EasyLog WIFI Logger Quick Start Manual

1

Getting Started

The sensor will arrive partly charged but ideally you should charge it for 24 hours before use for optimum
performance. The sensor will automatically start recharging while connected to a PC or USB charger using the
USB cable provided.
The battery icon has three states:
Not Displayed
1
Battery OK
Installing software
The sensor may already be displaying a reading but it will not be configured or connected to your WiFi network
until you complete the product set-up.
To set up the unit use our free EasyLog WiFi PC software available to download from the 'Software' section at
www.thermoworks.com/software.

Important Safety Information

WARNING: Failure to follow these safety instructions could result
in fire, electrical shock, other injury or damage.
Battery Replacement
The rechargeable battery in the EasyLog product should only be
replaced by ThermoWorks.
Repairing or Modifying
Never attempt to repair or modify EasyLog products. Dismantling
EasyLog products, including the removal of external screws, may
cause damage that is not covered under the warranty. Servicing
should only be provided by ThermoWorks. If the EasyLog product has
been submerged in water, punctured, or seriously damaged do not
use it before returning it to ThermoWorks.
Charging
Only use a USB Power Adaptor or a USB port on another device
to charge EasyLog products. Read all safety instructions for any
third party products and accessories before use with this product.
ThermoWorks is not responsible for the operation of any third party
accessories or their compliance with safety and regulatory standards.
We do not recommend charging the battery when the unit is at 104˚F
(40˚C) or above. Some of our products employ safety features to
prevent this.
Using Connectors and Ports
Never force a connector into a port; check for obstruction in the
port, make sure that the connector matches the port and that you
have positioned the connector correctly in relation to the port. If the
connector and port do not join with reasonable ease they probably do
not match and should not be used.
Disposal and Recycling Information
You must dispose of EasyLog products according to relevant laws and
regulations. EasyLog products contain electronic components and Li-
Po batteries and therefore they must be disposed of separately from
household waste.
Flashing
2
Battery Low - Recharge!
Solid
3
Battery Charging