DRAGONFIRE 01-2102 Installation Instructions

DragonFire Racing
3191 N. Washington St. Suite 2
Chandler, AZ 85225
1 (800) 708-9803
WWW.DRAGONFIRERACING.COM
Can-Am Maverick RacePace Nerf Bar Installation Instructions
Part # 01-2102 2013-2014 Maverick RacePace Nerf Bars (set of 2) – Black
Part # 01-2103 2013-2014 Maverick RacePace Nerf Bars (set of 2) – Red
Part # 01-2119 2015+ Maverick RacePace Nerf Bars (set of 2) –
Part # 01-2120 2015+ Maverick RacePace Nerf Bars (set of 2) –
Congratulations on your purchase of the DragonFire RacePace Nerf Bars. Designed to give your Maverick that racer style
as well as protection, these have been built with the serious off-road driver in mind. Customized mounts allow for full side
protection with minimal clearance loss. Accelerate your Maverick to RacePace today with DragonFire!
• Read and understand these instructions before installing product
• This product does not provide roll over protection
• Product does not guarantee protection from body damage
• Intended for recreational use only
Off road activities can be hazardous and could lead to injury, dismemberment, paralysis and death. No warranty
of representation is made as to the products ability to protect the user from any injury or death. The user assumes
that risk. The acceptance and /or use of this merchandise purchased from DragonFire by the customer hereby shall
release DragonFire from any and all liability pertaining to the use of such merchandise.

Step 1:

Place vehicle on a flat and level surface. Place gear selector in "Park" and remove keys from the ignition.

Step 2:

Prior to installation, remove the washer and nut from the rear mount of Nerf bar. Set hardware aside it will be re-used. (Figure A)

Step 3:

Locate the middle mounting tab extensions. Attach them to the center nerf bar mounts using supplied hardware. Leave loose for
adjustment and alignment to be done when mounts are fastened to frame. (Figure B)

Step 4:

For 2013 and 2014 models, slide adapter onto nerf bar end and secure with supplied 1/4-20 hardware. Torque to 10 ft-lbs (120 in-lbs)
(Figure C)

Disclaimer

DragonFire
Black
Red

Tools Required

1/2" Wrench
9/16" Wrench
7/16" Socket and Wrench
Ratchet