C-Tech Manufacturing CopBox Installation Manual

NUT INSERT INSTALLATION STEPS:
6.Slide hex tooling compression nut on to hex bolt 1/4
– 20 X 1-1/2" zinc. Make sure tooling compression nut
raised machined lip is away from hex bold head
7.Thread nut insert on to hex bolt – tooling compression
nut assembly. Nut insert flange should contact
machined lip on tooling compression nut.
8.Nut insert should be thread completely on to hex bolt /
tooling compression nut assembly.
9.Insert nut insert / tooling compression nut / hex bolt
assembly into pre-drilled hole in wall.
10.Using open end wrenches or ratchet socket, hold
tooling compression nut with open end wrench and
tighten the hex bolt to compress nut insert.
11.Do not over tighten nut insert. Nut insert should be
compressed to hold in wall.
12.Unthread hex bolt and tooling compression nut from
installed nut insert.
13.Use hex bolt and
tooling compression
nut for installation
of remaining nut
inserts.
WE BUILD IT BETTER
7501 Commerce Dr
Weston, WI 54476
715.355.8842
Dodge Durango

INSTALLATION GUIDE

T A C T I C A L