Advertisement
Quick Links
o p e r at i n g i n s t r u c t i o n s m a n u a l
HYDRO-GUARD
Remote
Pressure
Monitoring
System
2.1.1
!
WARNING:
Failure to read and follow the instructions contained within this manual
could result in serious personal injury, and/or damage to the Remote
Pressure Monitoring System.
1. Each person involved in the assembly, installation and/or maintenance
of the Hydro-Guard Remote Pressure Monitoring System must read
this manual carefully and follow all instructions prior to performing any
installation or maintenance procedures involving the Unit.
2. Be sure the corporation valve or other isolation valve is closed prior to
installation or removal of the pressure sensor.
3. Always use all necessary safety equipment and follow all recommended
procedures when installing, operating and maintaining the Hydro-Guard
Remote Pressure Monitoring System.
!
CAUTION:
When installing the Remote Pressure Monitoring System, ensure the known
pressure is less than 250psi. If pressure may exceed 250psi at identified
installation site, contact Mueller Co. for proper configuration.
®
www.muellercompany.com/hydro-guard
The content of this manual is the sole and exclusive property of Mueller Co.
Unauthorized distribution or reproduction strictly prohibited.
TABlE oF ConTEnTS
Reliable Connections
Customer Service Center
Decatur, Illinois
800.423.1323
moreinfo@muellercompany.com
PAGE
2-3
4
4-11
12
13
14
15
TM
Advertisement
Summary of Contents for MUELLER CO. Hydro-guard
-
Page 1: Table Of Contents
Reliable Connections Pressure Monitoring System. 1. Each person involved in the assembly, installation and/or maintenance of the Hydro-Guard Remote Pressure Monitoring System must read this manual carefully and follow all instructions prior to performing any Customer Service Center installation or maintenance procedures involving the Unit. -
Page 2: Installation And Site Evaluation
Pressure Monitoring System ® Installation and Site Evaluation General GPS Location Considerations into account and open the Device Each Remote Pressure Monitoring System, consists of an RTU and which is to be mapped. Select “Edit” Each Device contains a cellular Sensor, (here-by known as Device). - Page 3 Pressure Monitoring System ® Installation 4. After the drilling operation is 10. The pressure monitor will begin pressure level notifications, the complete and corporation valve is operating once the sensor cable following four (4) values may be closed, apply a suitable sealant or...
-
Page 4: Installation And Operating Instructions
(Warning High, the Mueller secure web page via the Warning Low, Critical High, and NOTE: The Hydro-Guard address: miwt.net. Once logged into Critical Low). Monitoring System registration the system, registered users can... -
Page 5: Operating Instructions
Pressure Monitoring System ® operating Instructions REGISTRATION PAGE: This page will allow the client administrator to enter a password; select how the system shall send event notifications (i.e., SMS- text messaging, email – both, or none); and time zone settings. - Page 6 Device open the Device SETTINGS web to measure and log transient activity. • TRANSIENT MONITORING page and locate the calendar function: The Hydro-Guard ® WARNING: Operating in application at the lower section of Pressure Monitoring System has the PRESSURE-TRANSIENT the management screen.
- Page 7 Pressure Monitoring System ® operating Instructions descrIptIon of the setup • Phone Number: The phone • High Warning and Low Warning: defined by the end user. User may define warning levels and critical number associated with the Pressure level at which the customer...
- Page 8 Pressure Monitoring System ® operating Instructions Transient Readings MIN / MAx / AVG MEASUREMENTS PAGE: From the Measurements page, the viewer can select a time frame to be viewed for the all units or select units. For example, by selecting “Month” all the data collected by an identified unit in the past month is shown on an operational curve of Pressure (psi) over that period of time.
- Page 9 1. Located the settings icon (Y) and 5. Click on the ExTRACT ALL AND LOGGING: The released button to open file location select; Hydro-Guard App 1.0.0 software preference screen. 2. Click on the Hydroguard App for the Hydro-Guard Pressure 1.0.0 link to download the application...
- Page 10 Pressure Monitoring System ® operating Instructions Mueller Tech Center Home Users Devices Measurements Description Pressure Warning Low Critical Low Warning High Critical High Test_Device: 3; Sensor Serial: 1419200209 56.1 175.0 180.0 PowerAnalyzer Device 262.0 270.0 Test_Device: 2; Sensor Serial: 1419200174 56.8...
- Page 11 Pressure Monitoring System ® operating Instructions ANALyTICS: The Hydro-Guard Monitoring System features an analytic function that allows an operator to compare ® measurements against one another for enhanced distribution system management.
-
Page 12: Battery Replacement And Technical
Pressure Monitoring System ® Battery replacement and Technical Information Battery replacement NOTE: Be sure to connect similar Batteries are field replaceable and can be ordered through Mueller color wires. Company. DO NOT disassemble the 4. Reinsert the antenna wire retainer. -
Page 13: Troubleshooting And Faq
Pressure Monitoring System ® Troubleshooting and FaQ trouBleshootInG and frequently asked questIons Troubleshooting Guide Q. Where is the data stored? Q. Are the Pressure Monitoring Systems SCADA compatible? Customer/User does not receive A. Customer specific data will be acknowledgement email when new A. -
Page 14: Parts
Pressure Monitoring System ® Parts replacement parts § descRiption ” Ø x 1 ” shoulder x ” - ” screw – SS Antenna/Composite Lid RTU (Remote Telemetry Unit) w/Lithium Batteries AJBV-4D Ductile Iron Adjustable Top – 12” L Mueller Composite Valve Box –... -
Page 15: Notes
Pressure Monitoring System ® Notes... - Page 16 Water (U.S.) International 1.800.423.1323 1.423.490.9555 www.muellercompany.com www.mueller-international.com Reliable Connections moreinfo@muellercompany.com international@muellercompany.com Copyright © 2018 Mueller Co., LLC. All Rights Reserved. The trademarks, logos and service marks displayed in this document herein are the property of Mueller Co., LLC, its affiliates or other third parties. Products marked with a section symbol ( § ) are subject to patents or patent applications.
Need help?
Do you have a question about the Hydro-guard and is the answer not in the manual?
Questions and answers