Glacier G2080TiFE Installation Manual

GLAC IER G2080Ti
PH-GB2080TiFE_BK01/CR01

PACKAGE CONTENTS

GLACIER GB2080TiFE
QTY: 1
GLACIER Stop Fitting
QTY: 2
WARNING - This product is intended for advanced users. Improper installation may result in damage to your equipment. While all e orts
have been made to provide the most comprehensive information possible, Phanteks assumes no liability expressed or implied for any damage(s)
occurring to your components as a result of using Phanteks cooling products, either due to mistake or omission on our part in the below
instructions, or due to failure or defect in the Phanteks cooling products. Do not disassemble the water block. Warranty will be voided.
Turn o the power to your system and discharge your body's static electric charge before proceeding with the installation procedure. If you do not
feel comfortable with performing the installation procedure, consult a quali ed computer technician.

STEP 1. REMOVING STOCK COOLER

Unscrew all highlighted screws to remove
the backplate and stock cooler.
Make sure to unplug the LED and Fan
cables when you remove the stock cooler.
Use the EVA-Foam from the box to use
as a base for your installation process.

STEP 2. APPLYING THERMAL COMPOUND

Clean o the original thermal compound.
We recommend using isopropanol alcohol.
Apply a drop of the Phanteks Thermal
Compound to the center of the GPU chip.
FOUNDERS EDITION
INSTALLATION GUIDE V1.0
For latest version check www.Phanteks.com
Thermal Pads
QTY: 3
M2,5x5 Screws
QTY: 15
Washers
QTY: 15
Thermal Compound
PH-NDC-01
QTY: 1
Phanteks D-RGB Cable
QTY: 1