Table of Contents
Advertisement
Quick Links
DALI-I-U DALI Input Unit
Installation guide
Introduction
The DALI-I-U DALI Input Unit has 4 inputs
which can be individually configured as digital
inputs for a DALI control system.
Press and Release actions can be defined
individually for each of the inputs through
software. This enables third party control
plates, sensors, door contacts etc. to be added
to the iLight DALI control network.
Dimensions
4mm Deep
41mm
*Do not extend cables
Installation
The unit should be installed in a dry
location, where ambient temperature
and humidity are within the operating
limits of the unit.
Warning
This device is classified as ELV.
Third Party devices used as input
devices for DALI Input Unit must have
mains rating (DALI bus provides basic
insulation only). Exposed conductive
parts must be earthed in accordance
with local wiring regulations.
Control wiring
Cable length
DALI-I-U
158mm*
connect to the DALI line (
Cable colours
Purple:
Blue:
Green:
Yellow:
Orange: COM
Red:
Brown:
includes 2 x polarity-free wires used to
0.5 mm²)
Input 1
Input 2
Input 3
Input 4
DALI bus
DALI bus
.
Advertisement
Table of Contents
Related Manuals for iLight DALI-I-U
Summary of Contents for iLight DALI-I-U
- Page 1 DALI-I-U DALI Input Unit Installation guide Introduction The DALI-I-U DALI Input Unit has 4 inputs which can be individually configured as digital inputs for a DALI control system. Press and Release actions can be defined individually for each of the inputs through software.
-
Page 2: Wiring Diagram
-40°C - +70°C All products manufactured by Eaton Lighting Systems and identified with the iLight product series mark are warranted to be free from defects in material and workmanship and shall conform to and perform in accordance with Seller’s written specifications.
Need help?
Do you have a question about the DALI-I-U and is the answer not in the manual?
Questions and answers