Approved Accessories - Motorola TX500 Manual

Hide thumbs Also See for TX500:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
s in
designed to provide reasonable protection against harmful interference in
ant
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
ive
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
e of
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
as

Approved Accessories

or
nic
Use of accessories not approved by Motorola, including but not limited to
ion
batteries, antennas, and convertible covers, may cause your mobile device
cal
to exceed RF energy exposure guidelines and may void your mobile device's
warranty.
Motorola recommends that you always use Motorola-branded chargers.
Motorola devices are designed to work with Motorola chargers.
For approved Motorola accessories, visit our Web site at: www.motorola.com
ave
an
Use & safety for battery-powered accessories
by
Your battery is designed to last the life of the product. It should only be
to
removed by a recycling facility. ANY ATTEMPT TO REMOVE OR REPLACE
YOUR BATTERY WILL DAMAGE THE PRODUCT.
ect
• Battery life may temporarily shorten in low-temperature conditions (-10°C
mful
for storage/use below 0°C for recharge) or permanently reduce in high
ed,
temperature conditions (above 60°C for storage/use or above 45°C for
ec.
recharge).
English
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents