Advertisement
Attach Base to Two Columns:
1. (Do not remove the screws indicated with the stickers)
2. Remove the three (3) 6mm Allen Screws (G) from each of the columns and set aside.
3. For proper orientation, match the column with the colored dot to the corresponding colored dot on
the base.
4. Place the base on top of the columns aligning columns with the holes on the base, the remaining
screw should be aligned to the larger hole on the base.
5. Secure the columns to the base using the three 6mm Allen screws (G) that were removed and set
aside earlier.
6. For casters, put a split washer and flat washer on each caster and attach casters to the base by
threading them into their corresponding holes on the underside of the base. Securely tighten the
casters using the wrench (L) supplied.
7. For glides, attach the glides to the base by threading them into
their corresponding holes in the underside of the base.
OPERATING INSTRUCTIONS:
1. To elevate top, manually pull the tabletop to raise the top to desired height. (No need to use the handles)
2. To lower top, squeeze both red handles located on each end simultaneously to release columns and
push down on the top to the desired height. Release handles at the desired height.
Rev. 04062018 BH
Page 2 of 2
Colored Dot
©2018 HAUSMANN INDUSTRIES, INC.
Advertisement
