Use of C485FX interface via USB ................. 7 Declare C485FX in USB mode in SENATORFX.NET ..........8 Use of C485FX interface with a MOD-TCPIP module ..........10 Declare C485FX in IP mode in SENATORFX.NET ..........11 Use of C485FX interface via serial port..............12 Declare C485FX in Serial mode in SENATORFX.NET ..........
You have just purchased “C485FX” communication interface created by EDEN INNOVATIONS. The entire EDEN INNOVATIONS team would like to thank you for your interest as well as your confidence in our security solution. We hope that you will be completely satisfied with the level of security it provides for your company’s premises.
Information and recommendations o In accordance with the European directive UTE C00-200 describing the directives 89/336 EEC and 92/31 EEC, C485FX complies with the following standards: NF EN 50081-1 for electromagnetic emissions and NF EN 50082-1 for electromagnetic susceptibility.
Technical manual C485FX – V1.3 p 6/16 Technical specifications Maximum consumption ....100mA @ 12V (external power supply) Power supply voltage ...... 9 - 14VDC Weight ..........112g ............0.25lbs Housing dimensions ......116 x 80 x 32 mm (116 x 80 x 35 mm with IP module) ............
Technical manual C485FX – V1.3 p 7/16 Use of C485FX interface via USB (cable supplied) Note: If you use several USB interfaces on the same PC, remember to configure the addressing switches. RS485 bus Screen Power Switch The power switch should therefore be positioned on ‘Alim. USB' (USB power).
Technical manual C485FX – V1.3 p 8/16 Declare C485FX in USB mode in SENATORFX.NET Select “Technique” in the right, then click on “Site configuration”. Right click on “Site Configuration“, and select “Create a network” in the context menu for a new installation.
Power switch (“External PS”) 12V/700 mA Note: To use the C485FX interface with a MOD-TCPIP module, you must use an external 12 V / 700 mA power supply. The power switch should therefore be positioned on ‘Alim. Externe’ (External power supply).
Technical manual C485FX – V1.3 p 11/16 Declare C485FX in IP mode in SENATORFX.NET Select “Technique” in the right, then click on “Site configuration”. Right click on “Site Configuration“, and select “Create a network” in the context menu for a new installation.
Power switch 12V/700 mA Note: To use the C485FX interface on a serial port, you must use a 12V / 700 mA external power source. The power switch should therefore be positioned on ‘Alim. Externe’ (External power supply). (?) Data sheet:...
Technical manual C485FX – V1.3 p 13/16 Declare C485FX in Serial mode in SENATORFX.NET Select “Technique” in the right, then click on “Site configuration”. Right click on “Site Configuration“, and select “Create a network” in the context menu for a new installation.
Need help?
Do you have a question about the C485FX and is the answer not in the manual?
Questions and answers