Advertisement
Installation Instructions
Part #SS450 - Rear Trac Bar
This product is designed to eliminate side shift of the rear axle
suspended on OEM leaf springs on the E-450 Chassis.
Installation time is 1.5 hours.
A qualified mechanic using normal automotive tools and following all safety
measures known should perform installation of this product. Components are
shown below
130-160
Advertisement
Table of Contents
Related Manuals for SuperSteer SS450
Summary of Contents for SuperSteer SS450
- Page 1 Installation Instructions Part #SS450 - Rear Trac Bar This product is designed to eliminate side shift of the rear axle suspended on OEM leaf springs on the E-450 Chassis. Installation time is 1.5 hours. A qualified mechanic using normal automotive tools and following all safety measures known should perform installation of this product.
- Page 2 Installation Instructions Part #SS450 - Rear Trac Bar A. Preparation Move the coach to a level, flat surface. If necessary, drive the rear wheels of the coach onto 4” high blocks and set the brakes or you may drive the coach over a work pit and chock the front wheels. Block off ade- quate space at the rear of the coach to work.
- Page 3 Installation Instructions Part #SS450 - Rear Trac Bar C. Installation of the Frame Bracket On the driver’s side, take frame bracket and install ¾” bolt so that the bolt head will be on the axle tube side of the bracket (See Figure 2). Install the frame bracket and nut plate to the frame rail. The frame rail must be between the nut plate and the frame bracket.
- Page 4 130 - 160 ft. lbs. Torque the jam nut to 100 - 150 ft. lbs. This completes the installation. Test drive. To register your product for warranty purposes, go to the SuperSteer website at www.SuperSteerParts.com and fill out the online registration card Re-check torque in 6 months.
Need help?
Do you have a question about the SS450 and is the answer not in the manual?
Questions and answers