LCD PROJECTOR LENS MODEL NO. LNS-W02/T02 LNS-W02K/T02K Series LENS REPLACEMENT AND INSTALLATION PROCEDURE NOTES ON LENS INSTALLATION Lens installation should be performed by the qualified service personnel. It should be followed by this procedure precisely. Before attempt to install the lens, confirm the model number (both the LCD projector and the lens) and use the proper lens.
Page 2
LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps First, set the lens at the center position with lens shift button. REMOVE THE LENS COVER. First check the shape of cabinet. In case figure-1 cabinet. Remove screws A (2 screws). Pull down the lower lens cover while pushing the part D, then remove it.
Page 3
● IN CASE OF MODEL WITH LENS REMOVE THE LENS. (See figure-4) 1. Remove the connector “K16B” of the circuit board. 2. Loosen the A, B, C wire holder and remove the lens motor lead. 3. Remove screws D (4 screws) which fastens the lens and remove the lens.
Page 4
INSTALL THE LIGHT-BLOCK SHEET. (See figure-6) Install the light-block sheet around the lens as shown in the illustration. (Use the sheet included with the lens.) MOUNT THE LENS COVER. (See figure-7) When in install the both upper and lower lens covers, put the light-block sheet through the lens and install the sheet so that it should be placed in the guide slot of the lens cover.