Advertisement
LENS REPLACEMENT AND INSTALLATION PROCEDURE
Perform the steps
First, set the lens at the center position with
lens shift button.
1
REMOVE THE LENS COVER.
First check the shape of cabinet.
In case figure-1 cabinet.
Remove screws A (2 screws).
1.
Pull down the lower lens cover while pushing
2.
the part D, then remove it.
3.
Remove screws B (2 screws).
4.
Remove screws C (2 screws) and remove
upper lens cover.
In case figure-2 cabinet.
Remove 4 screws of the lens cover and
remove the lens cover.
2
● IN CASE OF MODEL WITHOUT LENS
REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-3)
Remove 2 screws and pull down the plate.
(At the step
, insert the light-block sheet in the same
5
position as the removed cover plate has been placed.
Two screws are not used.)
Use the light-block sheet included with lens.
1
to
5
for lens replacement and installation.
Set the light-block
sheet, so that the
large rounder side
is set over the lens.
LIGHT-BLOCK SHEET
UPPER LENS COVER
B
D
D
A
LOWER LENS COVER
LENS COVER
SCREWS
COVER PLATE
C
Fig-1
Fig-2
Fig-3
Advertisement
