Advertisement
Quick Links
LCD PROJECTOR LENS
MODEL LNS-S30/S31
LENS REPLACEMENT PROCEDURE
NOTES ON LENS REPLACEMENT
Lens replacement should be performed by the qualified service personnel.
It should be followed by this procedure precisely.
Before attempt to replace the lens, confirm the model number (both the LCD
projector and the lens) and use the proper lens.
The lens cover is on the lens for protection. Be sure to remove the lens cover
before installation.
When installing or removing the lens, be careful not to stain, scratch or
damage the lens.
If you have any questions, contact the dealers.
Following parts are contained in the packing.
● LENS
● DRIVER (3 mm, Green)
● DRIVER (4 mm, Yellow)
● LIGHT-BLOCK SHEET
Following checks and confirmations should be taken for safety.
Check the following things by the time of the cabinet assembly after the lens
replacement.
1. Check the lens is securely fixed.
2. Check the proper wiring and the wires are fixed properly.
3. Check each connector is connected properly.
4. Check no wiring is tangled on the gear of lens motor or the other mechanical parts.
5. Check no parts is missing, or no mounting part is loose.
PARTS LIST
1 piece
1 piece (Part No. 610 287 7328)
1 piece (Part No. 610 275 6029)
For LNS-S30
1 piece Type PA1 (Part No. 610 285 3735)
For LNS-S31
1 piece Type PE1 (Part No. 610 293 9804)
1AA6P1P3245-- (IDEJ)
Advertisement
Related Manuals for Sanyo LNS-S30
Summary of Contents for Sanyo LNS-S30
-
Page 1: Parts List
LCD PROJECTOR LENS MODEL LNS-S30/S31 LENS REPLACEMENT PROCEDURE NOTES ON LENS REPLACEMENT Lens replacement should be performed by the qualified service personnel. It should be followed by this procedure precisely. Before attempt to replace the lens, confirm the model number (both the LCD projector and the lens) and use the proper lens. - Page 2 LENS REPLACEMENT PROCEDURE Perform the steps First set the lens at the fully lower position with lens shift adjustment. REMOVE THE LENS COVER AND FRONT CABINET Turn the lens cover to counter-clockwise and pull it toward front and remove the Lens Cover.
- Page 3 REMOVE THE LENS (See Figure-3 and 4) Remove the lens motor connector from terminal. Loosen the screws-B (2 screws) which fastens the lens. (Use the driver included with the lens to loosen the screws.) Slide the lens lock latches to "UNLOCK" position and remove the lens.
- Page 4 Use the sheet included with the lens. Make sure the part no. and mark (TOP and BACK) on Light-Block Sheet and set them properly. Mount the light-block sheet base. FOR LNS-S30 LIGHT-BLOCK SHEET BASE FRONT...