Related Manuals for Panther T-5
Summary of Contents for Panther T-5
- Page 1 55-0502 ODEL 55-0503 S ODEL INSTALLATION AND OPERATING INSTRUCTIONS CUSTOMER MUST RECEIVE THIS MANUAL AT TIME OF SALE OR AFTER INSTALLATION Rev 12/15...
- Page 2 Main Motor and Trolling Motor or the Transom & Trolling Motor. The T-5 installs much like our T4, with a few key differences noted here. Please read the en- tire install guide before starting. Installation is easy particularly when you know each step ahead of time.
- Page 3 3) Tighten the cable end of the T-5 to the solid rod if desired. Y ou may find the unit operates smoother by hand tightening the cable end to the solid rod and then backing them off 1/2 turn [to prevent any binding of the parts, don’t...
- Page 4 T-4/T-5 body (Picture 1) 2. The thread length on the tilt tube and the T-4/T-5 must be the same. To do this, simply count the threads on each. To increase the threads on the T-4/T-5, turn the nut counterclockwise. To de- crease the threads on the T-4/T-5, turn the nut clockwise.
- Page 5 Attach one ball stud to the front of your kicker motor and toward the same side as that of theT-4/T-5 drive rod.. Some motor manufacturers have a special bracket that can be purchased from them, (i.e. Mercury) that will eliminate the need to drill a hole.
- Page 6 If you own a motor that does not fit into either one of these categories then you will have to drill a hole in your motor to mount the ball stud. Look directly in front of the motor cover to determine where is the best place for you to drill a hole .
- Page 7 1. Place a ball stud through the hole in the drive rod and tighten it securely. 2. Cycle the T-4/T-5 so the drive rod is fully extended (see Picture) 3. Turn your motor all the way toward the drive rod.
-
Page 8: Operating Tips
2. Frequently check the ball studs. Make sure they are tight. 3. Depending on use, grease the T-4/T-5 at least once a year . 1 to 2 pumps of gr ease is sufficient. 4. Clean the drive rod at least once a season and lightly re-grease using the grease zerks on the motor. -
Page 9: Service And Warranty
SERVICE AND WARRANTY Should your unit ever require service, call the number below for special instructions on shipping and han- dling. Be sure to call between 8:00 AM and 4:00 PM (Central Time) Monday through Friday. If the ser- vice required is covered by the warranty, it will be repaired or replaced as described below. If the service required is not covered by warranty (such as damage caused from improper trailering or to the electrical controls), replacement parts are available for purchase and may be paid for by Visa or Master card. - Page 10 MarineTech Products, Inc. is proud to offer these fine lines SOLUTIONS FOR MOTOR MOUNTING, REMOTE STEERING, TILT & TRIM, SHALLOW WATER ANCHORS, AND SECURITY SYSTEMS THE ORIGINAL ENGINE-MOUNTED ELECTRIC TROLLING MOTORS—HIGH THRUST WITH WHISPER-QUIET EFFICIENCY ROD HOLDERS, TROLLING MOTOR SUPPORTS, AND GPS/SONAR MOUNTS AUXILIARY OUTBOARD MOTOR STEER SYSTEMS THROTTLE CONTROL FOR GAS POWERED AUXILIARY MOTORS...