Summary of Contents for PELWECKYJ VIDEOTECHNIK DSU-BOX
-
Page 1: User Manual
DSU-BOX DSU dome converter TTY / RS422, housing version User manual (issue 02.2017) -
Page 2: Symbol Meaning
DSU BOX – user manual Safety Before starting-up operation, maintaining, transporting, or storing – this product, read the safety advices for this product, as well as the entire instruction Pay attention to the warning notices in the succeeding chapters – Keep this document for later use or for handing it over together –... -
Page 3: Authorized Persons
DSU BOX – user manual Authorized Persons Danger of life for persons without necessary qualification Only skilled personnel are allowed to work on the device! Disregarding this can cause death, serious injury, or consider- able property damage. Warning This document does exclusively address the following target audi- ence: installer... - Page 4 DSU BOX – user manual Modifications of the device are only allowed as far as they are – mentioned in this document or explicitly allowed by the manufacturer Use only spare parts and accessories approved by the – manufacturer The device may only be operated when dry and undamaged –...
- Page 5 DSU BOX – user manual Introduction DSU module transfers video matrix’ Siemens SCU protocol of TTY interface to one dome protocol, which is provided at output port, RS485 (TX only) or RS422 (full duplex, reverse channel will not be used), respectively. According to firmware version, DSU is able to control dome cameras of several manufactures by using their specific communication proto- col, one protocol per each firmware version.
-
Page 6: Setting-Up For Operation
DSU BOX – user manual Number of Domes DSU module is able to control up to 32 domes on same bus, accord- ing to RS485 specification. It is possible to control up to 16 different domes at same time. If more than 32 domes should be controlled physically, or domes should be controlled in a star-shaped manner, a RS485/RS422 mul- tiplexer would be required, f.e. -
Page 7: Installation
DSU BOX – user manual Installation Connect DSU module “TTY input” to unused “Terminal” connector of SIMATRIX video matrix, by using a 1:1 direct connection cable (male/female, maximum length: 5m). DSU will be supplied with power from video matrix via this cable. Do not connect an additional external power supply to DSU! If distance between DSU and video matrix is greater than 5m, power has to be supplied by an external power supply 12V/200mA (not part... - Page 8 DSU BOX – user manual NCS – SivisMiniDome Switch Switch setting „off“ Switch setting „on“ – Video matrix baudrate 2400 Baud – Video matrix baudrate 4800 Baud – Video matrix baudrate 9600 Baud Dome baudrate 9600 Baud Dome baudrate 19200 Baud Dome parity „None“...
- Page 9 DSU BOX – user manual Camera specific functions of DSU Dome functions for which no standard key of control unit is assigned, can be accessed via position preset commands, instead. Used posi- tion presets are not further available, i.e. only position presets 1…60 and 73…99 are available (if supported by dome).
- Page 10 DSU BOX – user manual Pin assignment of DSU DSU BOX provides two 9-pole D-Sub connectors, a TTY input and RS422 output. TTY output connector is reservered and not used. RS422 output connector and connection status LED are located at front side of DSU.
-
Page 11: Transport And Storage
DSU BOX – user manual Maintenance Cleaning For cleaning use only a clean dry cloth – Do not use liquid cleaning agents or spray – Transport and Storage Keep the original device packaging for later transports – Do not expose the device to mechanical shocks –... - Page 12 DSU BOX – user manual Issued by Pelweckyj Videotechnik GmbH Güterstraße 2 64807 Dieburg Germany info@pelweckyj.de Issue 03.2016 12/12...