Download Print this page

LARSON Golight Manual

The power button power's the light on your Golight on/off. The Golight will continue to pan and

tilt with power supplied regardless of this setting.

B. The up, down, left and right arrows on the wireless remote control will move the Golight in the

corresponding direction. The Golight will rotate as long as power is supplied.

C. The tortoise/hare button sets the pan/tilt speed. Press it once for slower precise movement;

press it again for quick movement.

•

Remove battery cover: For wireless hand-held transmitter, remove Phillips head screw

to remove cover. For wireless dash mount remote, simply remove the exterior rubber

cover.

•

With battery compartment now exposed, gently remove old batteries by grabbing the

positive end and lifting up. Insert 2 X GP 23A 12V batteries according to the correct

polarity.

GOLIGHT REMOTE OPERATION

Table of Contents

Do you have a question about the Golight and is the answer not in the manual?

Page 1 The power button power’s the light on your Golight on/off. The Golight will continue to pan and tilt with power supplied regardless of this setting. B. The up, down, left and right arrows on the wireless remote control will move the Golight in the corresponding direction. The Golight will rotate as long as power is supplied.
Page 2 All lights within 200 feet of a controller (transmitter) must be disconnected from their power before completing this procedure. Golight controllers have a series of dip switches on the back of the controller. The dip switches are accessed by removing the battery cover. By default, all dip switches are set to the zero position.