Summary of Contents for progressive automations PA-40
- Page 1 PA-40 User Manual Contents Page 2 Features and Specifications Page 3 Operation Page 4 Operation Modes Page 5 Wiring Diagram...
-
Page 2: Features And Specifications
Features and Specifications “Plug & Play” – easy connection terminals. Can be set for wired override control. INCLUDED IN BOX Control Box Power Harness with in-line 30A fuse (Not designed to fail when there is too much load or obstruction of actuator) Wireless Remotes SPECIFICATIONS Control Ability... - Page 3 To reset the control box using the wired rocker switch, power off the control box. Press and hold the down button on the rocker switch and power on the PA-40. The down button must be held for 3 seconds while the control box is on. Once the PA-40 makes a beep, release the down button to initiate the Reset Procedure.
- Page 4 Operation Modes POSITION MODE OPERATION Press UP or DOWN to go Non-Momentary forward or backward. Press Control (default) it again to stop. Hold UP or DOWN to go Momentary Control forward or backward. Release it to stop. Both actuators will complete a full retraction, Primary extension and retraction.
- Page 5 Wiring Diagram A. WIRED ROCKER SWITCH 1. Extend 2. COM 3. Retract B. HALL EFFECT ACTUATOR 1. Signal 1 2. GND 3. +5 VDC 4. M+ 5. M- 6. Signal 2 C. POWER 1. Power +12V DC 2. Power COM...
Need help?
Do you have a question about the PA-40 and is the answer not in the manual?
Questions and answers
how to reset a pa 40 with rocker switch , after turning off power and holding down button then turning power on and beep ?
To reset a Progressive Automations PA-40 using a wired rocker switch:
1. Power off the control box.
2. Press and hold the down button on the rocker switch.
3. Power on the PA-40 while still holding the down button.
4. Continue holding the down button for 3 seconds after the control box is powered on.
5. Once the PA-40 beeps, release the down button to initiate the reset procedure.
During the reset, actuators cannot be controlled and will operate at half speed. The reset is complete when the control box beeps once, signaling readiness for operation.
This answer is automatically generated