Naked Cable HUB-6 IR Installation Manuals

Limited 3-Year Warranty
When purchased from an Authorised Dealer, Naked Cable warrants
the purchaser that this product will be free from defects in
materials and workmanship for 3-years. If a fault occurs please
supply with proof of purchase to the Dealer, or contact us directly
at the address below.
DETAILS Naked Cable or the Authorised Dealer will, at its option, repair or replace this product
at no additional charge. This Warranty does not include service or parts to repair damage
caused by accident, disaster, misuse, abuse, negligence, inadequate packing or shipping
procedures, commercial use, voltage inputs in excess of the rated maximum of the unit, or
service, repair or modification of the product which has not been approved by Naked Cable.
This warranty will be void if the Serial Number on the product has been removed, tampered with
or defaced.
CHANGES
In an attempt to improve our products, features and specifications
are subject to change without notice.
INSTALLATION TIPS
Check out our website for troubleshooting and
installation tips with this product.
www.nakedcable.co.nz (product support tab)
CONTACT US
0800 232 0023 | www.nakedcable.co.nz
info@connectedmedia.co.nz
HUB-6 IR Kit Installation Manual
INTRODUCTION
The Naked Cable Hub-6 IR (Infrared) System can receive signals from an
IR remote control and pass the signal through the Connecting Block, for
distribution to up to 6 components.
The IR Receiver can be mounted to any flat, clean surface (furniture
recesses, under shelves, etc.) using double-sided adhesive tape. The
emitter(s) mount on a suitable location on the component being controlled.
PACKAGE CONTENTS
The HUB-6 IR KIT (See Fig. 1) includes:
•
1 x Hub with mounting wings
•
1 x AU/NZ compliant power supply
•
1 x IR receiver (Red 3.5mm jack connector)
•
4 x Single emitters (Yellow 3.5mm jack connector)
•
2 x Dual emitters (Yellow 3.5mm jack connector)