Related Manuals for Vintage Air 55070-VCZ-A
Summary of Contents for Vintage Air 55070-VCZ-A
- Page 1 1969 CAMARO w/o FACTORY AIR 55070-VCZ-A 905070-VCZ-A 11/22/05 , 69 CAMARO w/o FAC. AIR INSTRUCTIONS PG 1 OF 20...
-
Page 2: Table Of Contents
1969 CAMARO w/o FACTORY AIR Table of Contents PAGES COVER TABLE OF CONTENTS PACKING LIST INFORMATION PAGE PASSENGER COMPARTMENT FIGURE 1 CONTROL CABLE INSTALLATION FIGURES 2-4 FIREWALL COVER INSTALLATION FIGURES 5 & 5A EVAPORATOR INSTALLATION FIGURES 6-7B EVAPORATOR INSTALLATION CONT. FIGURES 8-8C DUCT HOSE INSTALLATION FIGURE 9 ENGINE COMPARTMENT FIGURE 10... - Page 3 1969 CAMARO w/o AC ACCESSORY KIT ** BEFORE BEGINNING INSTALLATION OPEN ALL PACKAGES AND CHECK CONTENTS OF SHIPMENT. PLEASE REPORT ANY SHORTAGES DIRECTLY TO VINTAGE AIR WITHIN 15 DAYS. AFTER 15 DAYS, VINTAGE AIR WILL NOT BE RESPONSIBLE FOR MISSING OR DAMAGED ITEMS.
- Page 4 HEATER HOSE FROM VINTAGE AIR(31800-VUD) OR FROM YOU LOCAL PARTS RETAILER SAFETY SWITCHES: YOUR VINTAGE AIR SYSTEM IS EQUIPPED WITH A BINARY PRESSURE SAFETY SWITCH. A BINARY SWITCH (11078-VUS) DISENGAGES THE COMPRESSOR CLUTCH IN CASE OF EXTREME LOW PRESSURE CONDITION (REFRIGERANT LOSS) OR EXCESSIVELY HIGH HEAD PRESSURE (406 PSI), TO PREVENT COMPRESSOR DAMAGE OR HOSE RUPTURE.
-
Page 5: Passenger Compartment
1969 CAMARO w/o FACTORY AIR INSTALLATION INSTRUCTIONS 1969 CAMARO w/o FACTORY AIR BEFORE STARTING THE INSTALLATION, CHECK THE FUNCTION OF THE VEHICLE (HORN, LIGHTS, ETC.) FOR PROPER OPERATIONS. STUDY THE INSTRUCTIONS, ILLUSTRATIONS, & DIAGRAMS. PASSENGER COMPARTMENT DISCONNECT BATTERY REMOVE AND DISCARD THE OEM HEATER ASSEMBLY (#1). REMOVE AND DISCARD THE OEM DEFROSTER DUCT (#2). -
Page 6: Control Cable Installation
1969 CAMARO w/o FACTORY AIR FIGURE 2 CONTROL CABLE INSTALLATION REMOVE & REMOVE AND DISCARD (3) OEM CONTROL DISCARD CABLES FROM CONTROL PANEL. SEE FIGURE 2. ATTACH NEW CABLES (PROVIDED) TO CONTROL PANEL LEVERS AS SHOWN IN CONTROL FIGURE 3 BELOW. PANEL BACK POSITION LEVERS AS SHOWN IN FIGURE 4 BELOW. -
Page 7: Firewall Cover Installation
1969 CAMARO w/o FACTORY AIR FIREWALL COVER INSTALLATION USE THE OEM HEATER MOUNTING HOLE IN FIREWALL TO MOUNT THE FIREWALL COVER. APPLY A 1/4” BEAD OF SILICONE AROUND THE PERIMETER OF THE FIREWALL COVER AND INSTALL. SECURE USING (4) 1/4 x 1” HEX BOLTS WITH FLAT WASHERS, SEE FIGURE 5 BELOW. USE OEM HOLES IN THE FIREWALL TO MOUNT FIREWALL COVER... -
Page 8: Evaporator Installation
1969 CAMARO w/o FACTORY AIR EVAPORATOR INSTALLATION INSTALL THE (2) DEFROSTER VENTS UNDER DASH AS SHOWN IN FIGURE 6 BELOW. SECURE USING (2) #8 x ½” PH PAN HEAD SCREWS. INSTALL THE NEW DRIVER & PASSENGER SIDE FRESH AIR COVERS, SECURE USING OEM HARDWARE. -
Page 9: Evaporator Installation Cont
1969 CAMARO w/o FACTORY AIR EVAPORATOR INSTALLATION CONT. FIRST ATTACH DRIVER SIDE MOUNTING BRACKET IN OEM HOLE IN RADIO BRACKET USING OEM SCREW AS SHOWN IN FIGURE 8A BELOW. RAISE THE EVAPORATOR UNIT UP UNDER THE DASH AND ALIGN THE JACK-NUT IN THE EVAPORATOR UNIT WITH THE OEM HOLE IN FIREWALL (SEE FIGURE 5, PAGE 7). -
Page 10: Duct Hose Installation Figure
1969 CAMARO w/o FACTORY AIR DUCT HOSE INSTALLATION STRETCH THE DUCT HOSE OUT TO ITS MAXIMUM LENGTH AND CUT TO SIZES SHOWN. ROUTE DUCT HOSES TO CORRESPONDING LOUVERS AS SHOWN IN FIGURE 9 BELOW. NOTE: FOR MAXIMUM AIR FLOW MAKE SURE DUCT HOSES ARE PULLED TIGHT AND HAVE NO KINKS OR SHARP BENDS. - Page 11 1969 CAMARO w/o FACTORY AIR CONDENSER ASSEMBLY THE CONDENSER ASSEMBLY MOUNTS TO THE FRONT SIDE OF THE CORE SUPPORT. LOWER CONDENSER ASSEMBLY INTO POSITION. BE SURE THE TOP BRACKET IS BEHIND (FRONT LIP) FLANGE ON TOP OF THE CORE SUPPORT. FASTEN DRIVER SIDE LOWER CONDENSER BRACKET TO CORE SUPPORT USING 5/16"...
- Page 12 1969 CAMARO w/o FACTORY AIR CONDENSER INSTALLATION 10/24 (2) 5/16 U-NUT 10/24 x 3/8 STAR-NUT MOUNTED TO CORE O.E.M BOLT CONDENSER SUPPORT BOLT BRACKET BACK FRONT BACK FRONT TOP CONDENSER BRACKET (BEHIND CORE SUPPORT) 10/24 10/24 x 3/8 STAR-NUT BOLT DRIER S E R BRACKET...
- Page 13 1969 CAMARO w/o FACTORY AIR CONDENSER INSTALLATION CONT. LOCATE THE TWO #8 HARDLINES AND O-RINGS,INSTALL ON CONDENSER AND DISCHARGE HOSE. SEE FIGURE 13 BELOW AND FIGURE 12, PAGE 12. FASTEN THE HARDLINE TO THE FRONT OF THE DRIVER'S INNER FENDER PANEL WITH A #4 ADEL CLAMP AND A #10/32 x 1/2”...
- Page 14 1969 CAMARO w/o FACTORY AIR A/C HOSE INSTALLATION STANDARD HOSE KIT LOCATE THE #8 COMPRESSOR A/C HOSE. LUBRICATE (2) #8 O-RINGS (SEE FIGURE 1 1a, PAGE 11 ) AND CONNECT THE 135° w/ 134a SERVICE PORT FITTING TO THE #8 DISCHARGE PORT ON THE COMPRESSOR. ROUTE THE STRAIGHT MALE FITTING TO THE #8 CONDENSER HARDLINE.
- Page 15 1969 CAMARO w/o FACTORY AIR HEATER HOSE & HEATER CONTROL VALVE INSTALLATION ROUTE A PIECE OF HEATER HOSE FROM THE WATER PUMP TO THE FIREWALL AND ATTACH IT TO THE HEATER LINE FROM EVAPORATOR AS SHOWN IN FIGURES 14a, BELOW. SECURE USING HOSE CLAMPS. ROUTE A PIECE OF HEATER HOSE FROM THE INTAKE MANIFOLD, TO THE FIREWALL AND ATTACH IT TO THE HEATER LINE FROM EVAPORATOR AS SHOWN IN FIGURES 14a, BELOW.
- Page 16 1969 CAMARO w/o FACTORY AIR FRESH AIR 1/4-20 x 1” EVAPORATOR BOLT w/ WASHER FRESH AIR COVER INSTALLATION APPLY A 1/4” BEAD OF SILICONE AROUND THE BACK SIDE OF THE FRESH AIR CAP AS SHOWN IN FIGURE 15. ATTACH FRESH AIR CAP TO FIREWALL USING A 1/4-20 SILICONE x 1"...
- Page 17 EVACUATE THE SYSTEM AT LEAST 30 MINUTES AND CHARGE ACCORDING TO CAPACITIES ON INSIDE COVER PAGE. CHECK COMPLETE A/C ASSEMBLY FOR PROPER OPERATION. VINTAGE AIR RECOMMENDS THAT ALL A/C SYSTEMS BE SERVICED BY A CERTIFIED AUTOMOTIVE AIR CONDITIONING TECHNICIAN ONLY. SEE INSIDE COVER FOR SERVICE INFORMATION. 905070-VCZ-A 11/22/05 , 69 CAMARO w/o FAC.
-
Page 18: Air Conditioning Adjustments
1969 CAMARO w/o FACTORY AIR CAPILLARY TUBE COLDER COLDER COLDER COLDER CLOCKWISE CLOCKWISE CLOCKWISE CLOCKWISE THERMOSTAT THERMOSTAT THERMOSTAT THERMOSTAT (TYPICAL) (TYPICAL) (TYPICAL) (TYPICAL) ADJUSTABLE KNOB ADJUSTABLE KNOB (TYPICAL) (TYPICAL) WARMER WARMER WARMER WARMER COUNTER CLOCKWISE COUNTER CLOCKWISE COUNTER CLOCKWISE COUNTER CLOCKWISE CAPILLARY CAPILLARY CAPILLARY... - Page 19 1969 CAMARO w/o FACTORY AIR WIRING DIAGRAM 1969 CAMARO w/o FACTORY AIR WHITE VENT ENGINE VACUUM TUBING (BLACK) HEATER VALVE VACUUM TUBING (RED) CENTER LOUVER TEMPLATE PLACE ALONG EDGE OF DASH BOARD START ON CENTER LOUVER TEMPLATE OEM MARK 2 ½” ON DASH BOARD 7 3/4”...
-
Page 20: Evaporator Kit Packing List
1969 CAMARO w/o FACTORY AIR 1969 CAMARO w/o FACTORY AIR EVAPORATOR KIT EVAPORATOR KIT PACKING LIST 55070-VCZ-A QTY. PART No. DESCRIPTION 761169-VCE EVAPORATOR SUBCASE 782169-FCN 1969 CAMARO w/o AC ACCESSORY KIT CHECKED BY: PACKED BY: DATE: EVAPORATOR 761169-VCE ACCESSORY KIT 782169-FCN 905070-VCZ-A 11/22/05, 69 CAMARO w/o FAC. - Page 21 1969 CAMARO w/o FACTORY AIR 1969 CAMARO w/o FACTORY AIR ACCESSORY KIT ACCESSORY KIT PACKING LIST 782169-FCN QTY. PART No. DESCRIPTION 06200-VUE 2" DUCT HOSE 06250-VUE 2 1/2" DUCT HOSE 640164-PCA FRESH AIR CAP ASM 49880-VCI DRIVER SIDE VENT ADAPTER 33137-VUI GROMMET LARGE 49881-VCI...
- Page 22 1969 CAMARO w/o FACTORY AIR 1969 CAMARO w/o FACTORY AIR LOUVER ASM. KIT 490169-FCA CENTER LOUVER ASM. KIT PACKING LIST QTY. PART No. DESCRIPTION 49302-VUL ‘69 CAMARO CENTER LOUVER 498820-VCE ‘69 CAMARO CENTER LOUVER w/ (2) 2” HOSE ADPTR 65980-VUE “S”...
- Page 23 1969 CAMARO w/o FACTORY AIR 1969 CAMARO w/o FACTORY AIR WIRING KIT WIRING KIT PACKING LIST 23269-FCA QTY. PART No. DESCRIPTION 23123-VUW BUDDY CLIP 23143-VUW WIRE HARNESS 23149-VUW 30” BLACK JUMPER WIRE 49751-VUI SINGLE WIRE DIODE CHECKED BY: PACKED BY: DATE: WIRE HARNESS...
- Page 24 1969 CAMARO w/o FACTORY AIR 1969 CAMARO w/o FACTORY AIR INSTALLATION KIT INSTALLATION KIT PACKING LIST 632169-FCA QTY. PART No. DESCRIPTION 31050-VUD ½" DRAIN HOSE 18290-VUB ¼" x 1" COARSE BOLT 46103-VUH HEATER CONTROL VALVE 18233-VUB #6 x 3/8" PHILLIPS SCREW 18235-VUB #8 x 1/2”...
- Page 25 1969 CAMARO w/o FACTORY AIR 1969 CAMARO w/o FACTORY AIR INSTALLATION KIT INSTALLATION KIT PACKING LIST 63283-VCE QTY. PART No. DESCRIPTION 31050-VUD ½" DRAIN HOSE 18290-VUB ¼" x 1" COARSE BOLT 46103-VUH HEATER CONTROL VALVE 18233-VUB #6 x 3/8" PHILLIPS SCREW 18235-VUB #8 x 1/2”...
Need help?
Do you have a question about the 55070-VCZ-A and is the answer not in the manual?
Questions and answers