Kuryakyn 2596 Installation Instructions Manual

INSTALLATION INSTRUCTIONS
PLUG AND PLAY TRAILER WIRING, '14-UP FLH/FLT WITH 4-WIRE TRAILER
THANK YOU FOR CHOOSING KURYAKYN!
Protect yourself and others from possible injury and property damage or loss. Pay close attention to all instructions, warnings, cautions, and notices regarding the installation, use, and care of this product.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN POTENTIAL DEATH OR SERIOUS INJURY.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN MINOR OR MODERATE POTENTIAL INJURY.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN MAY NEGATIVELY AFFECT PRODUCT PERFORMANCE AND FUNCTIONALITY OR
DAMAGE THE PRODUCT ITSELF OR THE PRODUCT TO WHICH IT IS BEING ATTACHED.

ENSURE THAT THE FOLLOWING PARTS HAVE BEEN INCLUDED IN THE KIT:

1 Relay Module 4 Wire
1 4 Pin Trailer Plug Harness
1 Inline Blade Style Fuse Holder

YOU WILL ALSO NEED:

Wire stripper/cutter, wire crimpers, #2 Phillips screw driver, socket and ratchet set, in-lbs (Nm) torque wrench
THESE INSTALLATION INSTRUCTIONS CONTAIN IMPORTANT INFORMATION. ENSURE THE END USER RECEIVES THIS COPY AND IS AWARE
OF ITS IMPORTANCE FOR FUTURE USE.
A FACTORY SERVICE MANUAL WILL BE HELPFUL IN PERFORMING THIS
INSTALLATION. DO NOT ATTEMPT TO PERFORM THIS INSTALLATION
IF YOU ARE NOT CONFIDENT IN YOUR ABILITY TO COMPLETE ALL OF
THE STEPS IN THE PROCEDURE; CONSULT A TRAINED TECHNICIAN.
IMPROPER INSTALLATION COULD RESULT IN SERIOUS INJURY OR
DEATH.
ACCIDENTAL VEHICLE START-UP COULD CAUSE DEATH OR SERIOUS
INJURY, REMOVE THE MAIN FUSE BEFORE PROCEEDING.

STEP 1

Read and understand all steps in the instructions before starting the
installation. Park the motorcycle on a hard, level surface and turn off
the ignition. Let motorcycle cool.

STEP 2

Refer to PIC 2. Remove motorcycle's seat, left side saddlebag (if
applicable), left side cover, and the main fuse. Set all aside, they will
be reused.

STEP 3

Refer to PIC 3 and 4. Remove the two (2) mounting screws holding the
top caddy and Electronic Control Module (ECM) in place. Lift the ECM
up to gain access to the battery.
PAGE 1
302596
DPF-MRK-003 REV A 2/10/17
1 Hardware Kit, containing:
1 Blue Butt Connectors 16-14 Gauge
1 Blade Fuse 15A
1 Ring Terminal 16-14 American Wire Gauge (AWG), 1/4" Stud
4 PIN
TRAILER PLUG
HARNESS
FRONT OF BIKE
INLINE BLADE STYLE
FUSE HOLDER
RELAY
MODULE 4
WIRE
PIC 3
K U R YA K Y N . C O M
866 277 9598 | INFO@KURYAKYN.COM
454 COUNTY ROAD VV SOMERSET, WI 54025
2596
PIC 1
HARDWARE
KIT
PIC 2
PIC 4