Advertisement
Tools Required:
•
Phillips Head Screw Driver
•
Flat Head Screw Driver
•
Crimping Tool
•
7/16" Socket with Ratchet & Extension (To Remove Collector Cover)
•
Wire Puller
COLLECTOR ASSEMBLY
6
Actions Required:
1. Remove Collector Cover, Junction Box Cover (if present) and Drum Insert (if present).
2. Route wire into drum and through the hub. For reels with a drum insert the cable must first
be routed through the grommet in the insert before going into the drum.
3. Attach wires to corresponding leads on collector ring using appropriate connectors. Verify
reel & cable do not bind on rotation.
4. Make corresponding in coming connection in the junction box (if present) or route incoming
wires to the back side of the collector plate.
5. Check wire continuity from input to output. Reinstall drum insert and attach cable to drum
using a cable clamp.
6. Reinstall collector cover and junction box cover.
7. Reconnect all power sources and wind cable onto spool.
7 a. For spring powered reels refer to TSB 2013-07-005 for installation instructions.
PDF 1-18
3
1
2
2 of 2
4
7
COLLECTOR ASSEMBLY PARTS
5
1
2
3
4
5
6
7
Slip Ring
Brush Assembly
Liquid Light Conduit
Junction Box
Butt Splice
Outlet Wire
Inlet Wire
Form H-1801-TSB
Advertisement
