Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Acoustic Research AV100 B
Summary of Contents for Acoustic Research AV100 B
- Page 1 AV100 B/C AM/FM RADIO WITH iPod DOCKING FEATURE Owner’s Manual...
- Page 2 Congratulations Thank you for purchasing the Acoustic Research AV100 AM/FM Radio Receiver System with iPod compatibility. The B or C suffix after the model number indicates a black (B) or cherrywood (C) cabinet. Besides featuring standard AM and FM radio reception with dedicated antenna input connections, the AV100 also provides an iPod docking connector for listening to downloaded material from the internet when the iPod mode is selected.
-
Page 3: Fcc Information
FCC Information Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful in- terference in a residential installation. - Page 4 AV100 System Components Remote Control with Battery AV100 AM/FM Radio with iPod Docking Feature (iPod Not Included) AM Antenna FM Antenna AC Line Power Cord AV100...
-
Page 5: Power On/Off
Installing and Setting Up the AV100 You can begin to enjoy your AV100 Radio system as soon as the installation is completed as follows: 1. Determine the desired area where the unit is to be installed; i.e., table top, stereo cabinet, etc. Note: If possible, the unit should be positioned near a window to achieve the best reception with the AM and FM antennae. -
Page 6: Mode Button
MODE Button Each time the MODE button is pressed, the operating status of the unit changes in sequence from AM through AUX 2; as the mode changes, the associated blue LED lights accordingly. When the AV100 is turned off, the last operating mode in effect at the time is re-established when the unit is again turned on. - Page 7 Functions of Controls, Indicators and Connectors AV100 AV100 Radio System, Rear View AV100 Radio System, Top View AV100 Radio System, Front View...
- Page 8 Functions of Controls, Indicators and Connectors (Cont) 1. POWER ON/OFF Rocker Switch: When pressed to the ON ( I ) position, AC input power is applied to the radio system, placing it in the standby mode. 2. AC IN Power Connector: 2-prong male power connector for power cable connection to 120V, 60Hz power. 3.
- Page 9 AV100 Operation Preoperational Considerations Prior to operation, perform the following steps: 1. Remove the protective film from the battery compartment of the remote control. 2. Connect the power and antenna cables to the AV100 as outlined previously. 3. Apply line power to the AV100 by pressing the line power rocker switch on the rear of the unit to the on (I) position;...
- Page 10 Charging the iPod: The iPod’s battery is charged when the AV100 is switched on (independent of the input source selected). This charging function is not supported in the standby mode. Special AV100 iPod Features The AV100 iPod feature is compatible with the following models: iPod-Classic 5th generation (color display) 20GB 30GB...
-
Page 11: Specifications
Specifications Frequency Range: AM (UL) FM (UL) Power Amplifier: Input/Output: Input Output Dimensions (W x H x D) AV100 530kHz - 1710kHz 87.5MHz - 108MHz 2” x 3” magnetic shielded speaker, 10 W RMS @ 10% THD, Frequency Response: 80Hz - 20kHz 120 VAC 60Hz power supply 300 Ohm twin lead to connect the AM antenna 75 Ohm F-connector to connect the FM antenna... - Page 12 © 2007 Audiovox Electronics Corporation, 150 Marcus Blvd., Hauppauge, NY 11788 128-8246 AV100...