Advertisement
EQ9.0 USER MANUAL
1. Power Connections for input power, chassis ground, and remote turn-on, use a
minimum of 18 gauge copper wire for power and ground connections; power wire
should be fused with 1 Amp fuse
2: RCA Front & Rear Outputs RCA output jacks provide a fadeable-full range signal to
your front and rear amplifiers
3. RCA Inputs allow for a normal stereo signal input from various sources
4. RCA Sub Output provides a low pass signal to your bass amplifier
5. AUX Input Gain Adjustment is used to match the input level with the output level of
the source unit connected to the AUX input. When properly adjusted both sources
(AUX and Main) should play at the same volume level. The adjustments are individual
with one for the left and one for the right channel
6. Low Pass Frequency (LPF) Adjustment controls the cutoff frequency of the LPF on
the "Sub Out" channels, the crossover filter is switchable from 45Hz to 60Hz.
7. Subwoofer Level Adjustment raises and lowers the level of just the "Sub Out"
channels to fine tune level based on musical content
8. Volume Control raises and lowers the volume on all of the outputs simultaneously
9. Fader Adjustment allows you to adjust the level between the Front and Rear
channels
10. Input Selector Switch selects the Main/Aux
11. Equalizer Level Adjustment 9 individual controls at set at fixed frequencies of
50Hz, 125Hz, 250Hz, 500Hz, 1KHz, 2KHz, 4KHz, 8KHz and 16KHz with ±10dB of
adjustment one each
3
4
L
R
L
R
L
R
SUB OUT
AUX IN
MAIN IN
AUX
MAIN
LOW PASS
LEVEL
LEVEL
FREQUENCY
5
45Hz
60Hz
6
9 BAND GRAPHIC EQUALIZER
10
AUX
MAIN
SUB MASTER
FADER
50Hz
125Hz
250Hz
9
7
8
2
1
L
R
L
R
REAR OUT
FRONT OUT
500Hz
1KHz
2KHz
4KHz
8KHz
16KHz
11
Advertisement
