Page 3
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION! The amplifier runs on 230V AC voltage. Removing the cover will expose you to a potentially dangerous voltage! Do not use the unit if the electrical power cord is frayed or broken.
Page 4
GENERAL DF series with DSP (DF1400 , DF2000 , DF3200 ) are modern amplifiers for professional entertainers, who require maximum performance and sound quality on a limited budget. Amplifiers are designed for application in PA systems with high requirements for precise tuning of the parameters, but without the need for operative change.
Power Supply Unit Both channel of the amplifier share the same pulse power supply unit. Power Factor Correction (in DF2000 DSP only) The amplifier has power supply with Power Factor Correction, which significantly reduces load to the mains and also reduces noise and distortion in the mains. What is more important, the amplifier output power is no longer rigorously dependent on the mains voltage.
Page 6
Moreover, in the Download section you can find: SigmaStudio User Manual – user guide on setting built-in amplifers with DSP by SigmaStudio. SigmaStudio Video Tutorial – video tutorial about setting amplifers with DSP by SigmaStudio. Limiter’s User Manual – recommendations on limiters setting in signal processing tracts;...
FUNCTIONAL FEATURES Overload and Short-Circuit Protection Individual per each channel. This protective system becomes active in case of short- circuited output or overload caused by reduced load impedance. It disables the output signal of the respective channel for 0.5 second and then the amplifier gradually resumes its delivery.
4 min 1 2 3 Model (CH 1-2) Power Requirements 4 min Serial No CH 2 INPUT INPUT Park Audio II, Ltd Made i n Ukraine OUTPUT B CH 2 CH 1 OUTPUT A (POST DSP) (POST DSP) MAINS IN PUSH...
CABLE REQUIREMENTS Input Cables Make sure to use only shielded cables whether balanced or unbalanced. Shielding, when properly grounded, protects a signal against external electrical interference. As a rule, unbalanced lines over 3 meters long are not acceptable. Greater distances require a balanced cable.
INPUT AND OUTPUT CONNECTORS Input Connectors Use XLR (male) connectors to connect to the amplifier inputs and XLR (female) connectors to line outputs. See the wiring on the figures below. XLR (female) XLR (male) Cold « – » Cold « – » Shield (Ground) Hot «...
RACK-MOUNTING REQUIREMENTS The amplifier is designed to fit a standard 19” rack. While mounting, make sure to provide unhindered air access to the front and rear sides of the rack. Fan direction is from front to back. It is not necessary to leave empty space above or below the amplifier. For stationary use, it will be enough to fix securely only the front panel of the amplifier to the rack.
Page 14
AMPLIFIER OPERATION MODES The amplifier can operate in two or one-channel modes (respectively: each channel independently, the two channels in a bridge mode). The amplifier has two input channels. Signals routing for four channels is performed by the DSP engine. DSP settings control, presets storing and the creation of the original signal processing template is performed by personal computer with SigmaStudio editor, installed to it.
SPECIFICATIONS Number of input channels Number of output channels 2 Speaker Out, 2 Line Out (Post DSP) Number of operating modes Output Power: – DF1400 2 x 700 W / 380 W (4 / 8 Ohm, ~230V) 1400 W (bridge, 8 Ohm, ~230V) –...
Page 17
1 2 3 Model (CH 1-2) Power Requirements 4 min Serial No CH 2 INPUT INPUT Park Audio II, Ltd M ade i n U kraine OUTPUT B CH 2 CH 1 OUTPUT A (POST DSP) (POST DSP) MAINS IN...
Page 18
1 2 3 Model (CH 1-2) Power Requirements 4 min Serial No CH 2 INPUT INPUT Park Audio II, Ltd M ade i n U kraine OUTPUT B CH 2 CH 1 OUTPUT A (POST DSP) (POST DSP) MAINS IN...
Page 19
1 2 3 Model (CH 1-2) Power Requirements 4 min Serial No CH 2 INPUT INPUT Park Audio II, Ltd M ade i n U kraine OUTPUT B CH 2 CH 1 OUTPUT A (POST DSP) (POST DSP) MAINS IN...
Page 20
1 2 3 Model (CH 1-2) Power Requirements 4 min Serial No CH 2 INPUT INPUT Park Audio II, Ltd M ade i n U kraine OUTPUT B CH 2 CH 1 OUTPUT A MAINS IN (POST DSP) PUSH PUSH...
Page 21
1 2 3 Model (CH 1-2) Power Requirements 4 min Serial No CH 2 INPUT INPUT Park Audio II, Ltd M ade i n U kraine OUTPUT B CH 2 CH 1 OUTPUT A (POST DSP) (POST DSP) MAINS IN...
Page 22
1 2 3 Model (CH 1-2) Power Requirements 4 min Serial No CH 2 INPUT INPUT Park Audio II, Ltd M ade i n U kraine OUTPUT B CH 2 CH 1 OUTPUT A MAINS IN (POST DSP) PUSH PUSH...
Page 23
1 2 3 Model (CH 1-2) Power Requirements 4 min Serial No CH 2 INPUT INPUT Park Audio II, Ltd M ade i n U kraine OUTPUT B CH 2 CH 1 OUTPUT A (POST DSP) (POST DSP) MAINS IN...
Page 24
PARK AUDIO II, Ltd. Vinnytsia, Ukraine www.parkaudio.ua e-mail: park@parkaudio.ua...