FrSky XSR-SIM Instruction Manual

Introduction

The FrSky Wireless USB Dongle For Simulator (Model name: XSR-SIM) allows you to wirelessly connect your
FrSky transmitter to computer to use simulator. Then bind your transmitter to it, now you can move freely while
using a simulator.
Overview

Specifications

• Size: 48.2*19.1*9.2mm (L*W*H)
• Compact design
• Low power requirements: typically 55mA
• Compatible with FrSky transmitters and module systems (Mode D16）
• Compatible with popular simulators (DRL、LiftOff、Freerider、HotProps、etc.)
• 8 proportional channel and 8 switch channel output (set on the transmitter side )
• Firmware Upgradable (through the S.Port)

LED Status

Green LED Red LED
ON Flashing
Flashing OFF
OFF Flashing

Binding Procedure

Follow the steps below to finish the binding procedure.
1. Put the transmitter RF module into binding mode
1.1 For Taranis Series transmitters, turn on the transmitter, go to the MENU-MODEL SETUP—PAGE 2, choose
Internal or External RF-- Mode D16, then select Bind (OpenTX 2.2.2 and its improved versions are strongly
recommended).
1.2 For Horus Series transmitters, turn on the transmitter, go to RF SYSTEM—Mode D16, choose Internal or
External RF, and select BIND under STATE.
Instruction Manual for FrSky XSR-SIM
BIND
Status
Binding
Normal
Signal Lost
BIND