Advertisement
4.3.
Attach the front and rear frame together using the smaller side braces with the double tabs, insert at the top and bottom of the frames
(fig.3A). Ensure again they are the correct way up and that the locking castors are at the front.
4.4.
Between the two uprights Install the centre braces (single tab) half way up the frames. See fig.3B.
4.5.
TPS36 ONLY - As well as the side braces attach front and rear beam (single tab) exactly half way up the frame, front and back (fig.3B).
fig.3
4.6.
Insert the remaining cross beams in the frame using fig.4 and fig.5 to space them correctly. Ensure the beams are the correct way
around to hold the wire shelves (fig.4, fig.5). As before use a soft faced mallet to tap the beams into place.
© Jack Sealey Limited
fig.2
Original Language Version
fig.4
TPS22,TPS36,TPS72 Issue: 3(SP) - 18/03/17
Advertisement
