Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for DOnetworks DOFree
- Page 1 Free Manual Wireless Headset & Dongle...
-
Page 2: Table Of Contents
CONTENTS Introduction FCC Notice III. Features Included in This Kit Location of Controls Description of Key Components VII. Specifications VIII. How to Use For the Best Use Troubleshooting Warranty Guideline... -
Page 3: Introduction
LED and audible status indicators. Much work has gone into making the DOFree as practical and easy to use as possible. The ear loop is flexible enough to fit most ears and sturdy enough to hold the headset firmly in place. -
Page 4: Features
DOFree is ultra lightweight; extremely portable, comfortable to wear for a long phone call. DOFree is easy to quickly and conveniently put the headset on your ear, and to take off again and easy to use the control buttons on the headset. -
Page 5: Included In This Kit
Compatibility with Non Bluetooth cell-phone The Dongle of DOnetworks enables to use the Bluetooth headset for the non Bluetooth cell-phone user. The Dongle is ultra lightweight, micro-sized, stylish designed. -
Page 6: Location Of Controls
Location of Controls Bluetooth Headset Dongle(Audio Gateway) -
Page 7: Description Of Key Components
VI. Description of Key Components Headset Talk Button(☎) On/OFF and Redial Functions. Receiving or Hang up a call Volume Up(△) & Down(▽) Button : Volume Control LED Lamp Indicate On/OFF(Green Lamp) Indicate Charging status(Red Lamp). Speaker : Make beep sound when a button on the headset is pressed and Receiving a phone call. -
Page 8: How To Use
- Voice transmission : A-Law, u-Law, 13 or 16bit PCM (8ks/s) - Transmitter Power : 0dBm - Battery Voltage : Headset 3.7v Li-ion Polymer (160mAh) Dongle 3.7v Li-ion Polymer (210mAh) - Material : Plastic - Permitted Temperature : -10°C to +50°C - Continuous Talk Time : 5 Hours - Standby Time : 80 Hours - Operating Range : up to 10M... - Page 9 4. Registering (Pairing) Headset for cellular phones with Bluetooth Headset profile. ■ Registering Headset with Dongle. DOFree Headset and Dongle are paired at the factory. However, there are instances where you will need to pair the Headset and Dongle (such as using the Headset after pairing it with a Bluetooth cellular phone, etc.).
-
Page 10: For The Best Use
Gateway) will flash with short burst every 2 to 3 seconds, indicating the stand-by mode. ※ IMPORTANT NOTICE: To reduce battery consumption, the Headset and Dongle(Audio Gateway) will automatically switch to “stand-by”mode after 30 seconds from the end of an operation. You will notice this by the LED’s short flashes on both the Headset and Dongle(Audio Gateway). -
Page 11: Warranty Guideline
•Check if the Headset is ON. •Make sure the Headset and Dongle(Audio Gateway) batteries are charged. •Check the distance between the Headset and Dongle(Audio Gateway)(normal operating distance between the Headset and Dongle(audio Gateway) should not exceed 10 meters, or 33ft.) 2.If the LED lamps on the Headset and the Dongle(Audio Gateway) do not light. - Page 12 SUBJECT TO THE FOLLOWING TWO CONDITIONS: ( 1 ) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND ( 2 ) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFEERENCE THAT MAY CAUSE UNDESRIED OPERATION DOnetworks Co.. LTD. 3F, Yangjae Bldg, #264-3, Yangjae-dong, Seocho-gu, Seoul, 137-130, Korea Tel : 82-2-576-4620 Fax : 82-2-576-1760 http://www.donetworks.co.kr...
Need help?
Do you have a question about the DOFree and is the answer not in the manual?
Questions and answers