Advertisement
Handle
Installation set-up with Mythos
with 2
people!
1. Slide the back of Puqpress M2 over the edge of
2. While lifting the Mythos to place on Puqpress
the table or bar where you want to use your set-up.
M2, guide the Mythos cable from top to bottom
through Puqpress.
Connect the Puqpress cable inside in its socket.
3. Choose 1 of 3 directions to guide both cables out. Press the
4. Carefully slide the set-up back onto the bar or table and
Puqpress cable in the cable-guide behind the clip. Position the
make sure its standing level.
Mythos cable in the other cable-guide (without clip).
Hey there!
Set up the Lower Clamp,
before you do anything else.
Only
then, every tamp will be perfectly level
and safe.
Set-up
Cleaning during your shift
with 2
people!
For instruction videos check www.puqpress.com/support
Coffee can stick to your tamper while
making coffees. Give it a quick wipe
with a dry towel or cloth and you're
good to go again!
Advertisement
Table of Contents
Related Manuals for Barista Technology Puqpress Mythos V7
Summary of Contents for Barista Technology Puqpress Mythos V7
- Page 1 Hey there! Handle Installation set-up with Mythos with 2 Set up the Lower Clamp, before you do anything else. people! Only then, every tamp will be perfectly level and safe. Set-up Cleaning during your shift with 2 people! For instruction videos check www.puqpress.com/support Coffee can stick to your tamper while making coffees.
- Page 2 NEW TAMP SETTINGS Once Set up the lower clamp Maintenance every week A. Activate menu 1. Switch off the power. 2. Press ‘CLEAN’ Press and Hold the ‘CLEAN’ and button to step ‘+’ button while the power is through menu switched back on.
Need help?
Do you have a question about the Puqpress Mythos V7 and is the answer not in the manual?
Questions and answers