FS-PP v2 Fixture Mount Power Pack SPECIFICATIONS Power ..........120/277/347VAC, 60Hz Relay Type ....Form C with Zero Crossing on N.O. only Output ......70mA @ +24VDC with relay connected Load Requirements @120VAC .........5.0A (N/O), 3.0A (N/C), 1/6hp @277VAC .........4.3A (N/O), 2.5A (N/C), 1/6hp @347VAC ..........
This cable carries power to the sensor and lighting control signals to the power pack. Each Watt Stopper FS-PP v2 can supply power for up to seven FS series low voltage sensors. FS-CK accessory kits are required to connect multiple sensor or multiple power pack wiring configurations.
Page 3
Control 120/277/347 Volts AC Green Operation RJ45 Lighting Plug Neutral Load from FS sensor Fig 2: FS-PP v2 direct wiring to lighting load 0-10VDC Ground Model: Fixture Sensor Power Pack GROUND Violet FS-PP V2 120/277/347VAC, 60Hz @120VAC 5A (N/O) Neutral...
Page 4
CONTROL CONFIGURATIONS Standard connection between FS sensor and FS-PP power pack Any 24VDC FS-Sensor FS-PP Fig 5: One sensor controlling one Power Pack FS-PP One FS sensor connected to two FS-PP FS-C3 (3') FS-C4 FS-C1 (10' shown) Any 24VDC FS-PP FS-Sensor Fig 6: One sensor controlling two Power Packs Two FS sensors connected to one FS-PP...
TROUBLESHOOTING Lights will not turn on: • Sensor LED does not flash: - Is green power pack LED on? If yes, check RJ45 connections at sensor and power pack. If no, check circuit breaker and wiring to power pack. - Check all wire connections. •...
ORDERING INFORMATION Catalog # Description FS-PP v2 Fixture Mount Power Pack: 120/277/347VAC, 60Hz with NO/NC Relay output FS-105 Ceiling tile mount, low voltage PIR occupancy sensor with adjustable time delay and light level FS-205 Fixture mount, low voltage PIR occupancy sensor...