Roadmaster Sterling handle replacement kit 910003-35 Installation Instructions

Towing and Suspension Solutions
ROADMASTER, Inc.
Read the instructions before installing the
kit components. Failure to understand how to
install this product could result in property
damage.

Kit components

This kit contains the components for two Sterling or
Sterling All Terrain handles —
(2) handle arms
(2) handle pads

Required tools

A 3/16" drift pin (or punch) and a hammer

Installation instructions

1. On the handle side of one of the locking mechanisms,
position the drift pin (or punch) over the roll pin and hammer
the roll pin down, approximately ½", until the handle can be
pulled away (Figure 1).
Do not hammer the roll pin down any farther than is
necessary to remove the handle. The locking pawl is
connected to the roll pin. If the roll pin is driven too far
down, the locking pawl will fall out, and the tow bar must
be completely disassembled in order to reposition it.
2. Insert one of the handle pads over one of the replace-
ment handles, and align the end of the handle with the 3/16"
hole over the hole for the roll pin.
These instructions contain information that is very important to know and understand. This information is provided for
safety and to prevent equipment problems. To help recognize this information, observe the following symbols:
WARNING indicates a potentially hazardous situ-
ation which, if not avoided, could result in property
damage, serious personal injury or even death.
CAUTION indicates a potentially hazardous situa-
tion which, if not avoided, may result in property dam-
age, or minor or moderate personal injury.
854535-01 08-14
6110 NE 127th Ave. Vancouver, WA 98682

IMPORTANT NOTICE!

Sterling handle replacement kit
for Sterling and Sterling All Terrain tow bars
Installation Instructions
All specifications are subject to change without notice
800-669-9690
3. From the other side of the handle, drive the roll pin down,
until the roll pin is flush to the edge of the handle (Figure 2).
4. Repeat for the other handle.

Safety Definitions

CAUTION used without the safety alert symbol in-
dicates a potentially hazardous situation which, if not
avoided, may result in property damage.
Refers to important information and is placed in italic
type. It is recommended that you take special notice of
these items.
part number 910003-35
Fax: 360-735-9300 www.roadmasterinc.com
NOTE
Figure 1
Figure 2