Loll Designs VANG Assembly Instructions & Product Info

ASSEMBLY INSTRUCTIONS
1
CONNECT BACK TO BASE
right connection block right connection block
Step 1 and repeat
Step 1 and repeat
*Please read Assembly Tips before beginning assembly.
Set Back and Base on their sides and align as seen above. Fit Left Connection
Block with the Back and Base's oval cut outs. Place Bolts through the holes in the
Connection Block into the threaded holes of the Back and Base. Finger tighten.
Repeat this step for the Right Connection Block then tighten bolts using provided
wrench.
Right Leg
3
ATTACH LEGS B & C
Step 3
Place Left Leg into Base side by pressing it into the oval cut.
* It is very important that you finger tighten all bolts into inserts to ensure that you do not cross-thread bolts and inserts before tightening. It
will also be easier if you wait to tighten bolts until you have all bolts installed and the piece completely assembled. This will allow for more
movement of individual pieces and help in aligning holes with inserts. Use the Allen Tool provided to finish tighten bolt until snug.
Right Leg
Step 3
2
ATTACH BRACES B
Left Connection Block Left Connection Block
Slide Left Leg long edge into pocket cut out in Face Plate.
4
ATTACH LEGS A & D
Step 4 (repeat steps 2-4 on other side) Step 4 (repeat steps 2-4 on other side)
Insert Bolts through Leg into the threaded holes of the Base and finger tighten.
Repeat steps 2-4 for Right Leg.
After both Legs are attached securely tighten using provided wrench.
7/8" Bolt (x12)
7/8" Bolt (x12)
Step 2
Step 2
Left Leg Left Leg