Download Print this page

Redback A 5110 DI Box Operating Instructions

Advertisement

Quick Links

REDBACK
®
Distributed by Altronic Distributors Pty. Ltd. Perth. Western Australia.
Phone: 1300 780 999 Fax: 1300 790 999
Internet: www.altronics.com.au
Page 4
O
PERATING
O
VERVIEW
Direct Injection (DI) boxes are used to convert high impedance unbalanced devices like guitar pick ups to
a low level balanced output. This is done to allow signals to be fed over long distances without hum and
noise pick up. This model can be powered from either an external 12V DC source, a 9V battery, or
powered directly by the equipment it is connected to ie: Phantom powered. This DI box has inbuilt EQ or
tone controls plus an overall level control. Two 6.35mm mono connectors are provided for the input and
"loop out", while a single 3 pin XLR is used for the output. An earth lift switch is provided to help
eliminate earth loops. A test switch is provided to test battery or phantom power availability. A "loop in,
loop out" power supply has been provided for powering other Redback Solutions products without the
need for individual 12VDC supplies for each unit.
S
PECIFICATIONS
Power: ..........................................................................9-28v DC.
Power Source: ..................Internal 9v battery (not supplied)
External 12v, or 24v, dc plugpack (not supplied)
Operating current: ............................................................10ma
Nominal Input Level:..................................-10dbm (245 mv)
Input Impedance presented: ......................300k unbalanced
Output Load required: ......................200~600 ohm balanced
Frequency Response:..........................20 Hz to 20Khz (±1db)
Gain: ....................................................................................Unity
Noise:..........................................................................> -60 dbm.
*Specifications subject to change without notice
Manufactured in Australia by Altronic Distributors Pty Ltd
Doc. BL1453
Doc. BL1453
www.altronics.com.au
REDBACK
®
A 5110 DI Box
I
NSTRUCTIONS
F
EATURES
• 6.35mm mono in out loop
• Treble, bass and mid volume
• Balanced 3 pin XLR out
• 12-24VDC or 9V battery operated
• Slide switch to select 9V battery power
• Switch for 9V battery or phantom power check
• Ground isolation switch
®

Advertisement

loading

Summary of Contents for Redback A 5110 DI Box

  • Page 1 A test switch is provided to test battery or phantom power availability. A “loop in, loop out” power supply has been provided for powering other Redback Solutions products without the need for individual 12VDC supplies for each unit.
  • Page 2 REDBACK ® REDBACK ® Legend Phantom Power LED Bass Level Control Power LED Battery Check LED Mid Level Control Power Switch Master Level Control Treble Level Control Fig. 1: Front panel layout. Legend 12-24VDC Input XLR output Battery Selector Switch 12-24VDC Output 6.35mm Loop Out...