Advertisement
GB
ISTT & ISTT-125:
I ndustrial Spring Tensioning Tool
ISTT use in combination with FlexiForce spring fittings and 1"shaft
ISTT-125 use in combination with FlexiForce spring fittings and 1¼"shaft
Max. Torque 210Nm
Max. RPM 2500
INSTALLATION, USE AND MAINTENANCE BY THE INSTALLER
© All rights reserved. FlexiForce
2017
®
www.flexiforce.com
User manual ISTT
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for FlexiForce ISTT
- Page 1 ISTT & ISTT-125: I ndustrial Spring Tensioning Tool ISTT use in combination with FlexiForce spring fittings and 1”shaft ISTT-125 use in combination with FlexiForce spring fittings and 1¼”shaft Max. Torque 210Nm Max. RPM 2500 INSTALLATION, USE AND MAINTENANCE BY THE INSTALLER ©...
- Page 2 DO NOT DISMANTLE OR BEND AWAY THE SAFETY LEVER FROM THE DRIVE UNIT CARRY OUT THE MAINTENANCE AS PRESCRIBED With the proper maintenance and correct usage the ISTT is suitable to tension at least 3000 torsion springs without any problems. www.flexiforce.com...
- Page 3 Maintenance and checks Maintenance and checks Check dimensions A,B,C and D ! Keep the teeth of the gear wheel clean and (See page 9,10 and 11) greased. Keep the bore of the gear wheel clean and Do not use the spring tensioning grease the surface of the bore before use.
- Page 4 Insert Gear Wheel Sickle Lever Drive Unit 95 122 991 95 122 991 rev. 30-10-2018 rev. 30-10-2018 Select ISTT & Insert Pin NEVER USE THE ISTT-125 ON A 1” SHAFT ! FF Sping plug SHAFT TOOL Insert Pin FF200 1” ISTT Ø13,3x43...
- Page 5 95 122 991 95 122 991 rev. 30-10-2018 rev. 30-10-2018 1” ISTT-GEARWHEEL 1” ISTT-125 GEARWHEEL 95 122 991 95 122 991 rev. 30-10-2018 rev. 30-10-2018 Check !!! 95 122 991 95 122 991 rev. 30-10-2018 rev. 30-10-2018 95 122 991 95 122 991 rev.
- Page 6 Check !!! Check !!! FF Spring plug Dim X FF200 20,6mm FF263 21,1mm Click !!! FF375 17,6mm Click !!! FF375N 17,6mm FF600N(-125) 30,6mm 95 122 991 95 122 991 rev. 30-10-2018 rev. 30-10-2018 95 122 991 95 122 991 rev. 30-10-2018 rev.
- Page 7 95 122 991 rev. 30-10-2018 rev. 30-10-2018 Use of the ISTT / ISTT-125 Select the correct version ISTT for used type of shaft Make sure that one always uses the plug! (page 7) During tensioning the driveshaft of the device will get warm, this is normal, the aluminium- casing will absorbe the heat.
Need help?
Do you have a question about the ISTT and is the answer not in the manual?
Questions and answers