Advertisement
This will save the new command into the sequence list as shown below. You can now send the command
to the Inclinometer by clicking on the "—>" button. This will print the command "setoasc" (Tx) into the
monitor window & and the inclinometer should respond (Rx) with "OK" to indicate success.
You can now create a 2nd command to request the angles from the Inclinometer.
Open the "Edit Sequence List..." as shown before and click on the ">" button to go to a new blank
command.
Create the new command "get-x&y" as shown below then click on OK.
(If you are using an LCH-360, use the command "get-360" instead)
8
A First Use Guide for LCH Inclinometers Using the RS232 Serial Interface.
Advertisement
