HPE FlexFabric 12902E User Manual page 2

Use your thumb and forefinger to squeeze the captive screw at the bottom and using
6
the other hand to hold the fan tray handle, push the fan tray into the slot until it stops.
7 Fasten the captive screws on the fan tray.
Removing the filler panel
1
Orient the fan tray
with the LEDs on the
left for slot FAN1
3
2
1
Orient the fan tray with the
LEDs on the right for slot FAN2
4
4
Removing the fan tray
When you remove the fan tray, do not touch the rotating fans to avoid getting injured.
!
1
Prepare an anti-static mat.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably
2
grounded.
Loosen the captive screws on the fan tray .
3
Using one hand to squeeze the captive screw at the bottom and the other hand to hold
4
the fan tray handle, pull the fan tray out of the slot.
5 Place the fan tray on the anti-static mat.
1
2
1