Advertisement
Quick Links
409S
Stainless Steel
®
Removal:
1)
Raise the vehicle up on a hoist or rack to working height. If you do not have access to a hoist
or rack, raise the vehicle and support securely with jack stands.
2)
Begin by applying a lubricant to each of the rubber exhaust isolators as well as the two front
flange bolts. This will make the removal and installation process much easier.
Installation:
Pg 1 of 4
3)
Support the muffler with a stand and remove the two bolts
at the front flange connection. Now, with the help of an assistant,
slide the exhaust system to the rear to disengage the hangers on
the exhaust from the rubber mounts on the vehicle. Once free,
the assembly can be removed by working it forward over the rear
axle (If you are working on the ground it may be easier to cut the
tailpipe off at the rear of the muffler to simplify removal).
1)
Mount the left rear tailpipe hanger bracket #226HA to the
frame on the driver's side of the vehicle. Place the included 3/8 x
3.50" bolt thru the 226HA hanger and into the hole indicated in
the photo. On the inside of the frame, place the HA226 back-up
plate over the bolt followed by a flat washer, lock washer and
nut. Using two 9/16" wrenches tighten firmly (Do not over
tighten).
Technical Support (707) 544-4761
Installation Instructions for:
SYSTEM #817725
2015 FORD F-150 TRUCK
2.7L, 3.5L & 5.0L ENGINE
Does not fit Standard Cab – 6.5' Bed
02/18/15
Advertisement
Related Manuals for Flowmaster AMERICAN THUNDER 817725
Summary of Contents for Flowmaster AMERICAN THUNDER 817725
- Page 1 Installation Instructions for: SYSTEM #817725 2015 FORD F-150 TRUCK 2.7L, 3.5L & 5.0L ENGINE Does not fit Standard Cab – 6.5’ Bed 409S Stainless Steel ® 02/18/15 Removal: Raise the vehicle up on a hoist or rack to working height. If you do not have access to a hoist or rack, raise the vehicle and support securely with jack stands.
- Page 2 Based on production variations this is a list of cab designs, bed lengths and wheel bases that outlines the requirements for the front inlet pipe. Please follow the instructions for your particular wheelbase listed below. Double check all measurements before cutting your inlet pipe: 141”...
- Page 3 Slide either the side exit pipe #86325S or rear exit pipe #86326S onto the ends of both over axle pipes. Place a clamp onto these slip-fit connections and tighten just enough to hold in position. Place the two stainless tips #ST461 onto the exit pipes and tighten the pinch bolts just enough to hold in position.
- Page 4 Installation diagram for: SYSTEM #817725 2015 FORD F-150 TRUCKS 2.7L, 3.5L & 5.0L ENGINE Does not fit Standard Cab – 6.5’ Bed 409S Stainless Steel ® Technical Support (707) 544-4761...