Ultra electronics EOTec MXB-MM2 Installation Instructions

Connections
Power: At the top of the module, a pluggable screw
terminal block is provided to apply power from a,
nominal 24Vdc source. The MX Base Module
provides this received power to all additional I/O
modules connected via the 10+2 integrated BUS
interconnection.
Alarm Relay: Also, at the screw terminal block are
contacts of a Form-C (SPST) Alarm Relay which
provide a remote fault indicator. There are four faults
that will engage the relay: An I/O module mismatch, a
loss of power, a loss of the optical signal, or a loss of
the optical signal at remote receiver will set this alarm
(engage relay).
SFP: MX Base modules use Small Form-factor
Pluggable (SFP) transceivers with LC connectors.
This replaceable transceiver determines the transmit
and receive specifications of the MX Base module.
Important Notice - Before utilizing the product, the user should
determine the suitability of the product for its intended use. The
user assumes all risk and liability in connection with such use.
ULTRA ELECTRONICS' WRITTEN WARRANTY FOR THE
PRODUCT IS MADE IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED
MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. The user's exclusive remedy for breach of Ultra
Electronics' written warranty shall be the repair or replacement of
such quantity of product which is proven to be defective. In no
case shall Ultra Electronics be liable for any special, incidental, or
consequential damages based upon
negligence, strict liability or other legal theory.
Safety and Warning Information
IEC 60825-1, Class 1 Laser Product
CAUTION: Use of controls and/or adjustments or the
performance
specified herein may result in hazardous radiation
exposure.
Modules shall be installed in an enclosure which
maintains an ingress protection rating of IP54 and meets
the enclosure
EN60079-15. The EOTec modules shall be installed in
DIN rail with DIN end clamps mounted on both sides of
the module set.
Protective Earth in order to provide modules with a
Protective Earth connection.
equipment connections or modules when energized.
Service of this equipment is to be performed by Ultra
Electronics, NSPI only.
replacement of parts. For installation manuals in a
community language other than English please contact
Ultra Electronics, NSPI.
Ultra Electronics
N
UCLEAR SENSORS & PROCESS INSTRUMENATION
707 Jeffery Way, PO Box 300
Round Rock, TX 78680-300 USA
Toll Free: 800-880-9333
Telephone: +1 512-434-2850
Fax: +1 512-434-2901
Email: fiberop@ultra-nspi.com
www.ultra-nspi.com
WARRANTIES OF
Ultra Electronics,
Instrumentation is a business name of Weed Instrument
.
Co., Inc
Approval Agency Controlled Document
breach of contract,
No changes authorized without prior agency approval
Publication Number:
When operating, do not look directly
into the transmit optical port or use
magnification or focusing equipment to
view optical output.
FDA 21 CFR 1040.10 & 1040.11
of procedures other than
Connect the DIN Rail, via the Model
2A09 End Clamp, to Protective Earth
(PE) ground with low impedance.
ATEX Specific Conditions of Use
requirements of EN60079-0
The DIN rail must be connected to
Do not disconnect
Service
This unit has no scheduled
Nuclear sensors &
RM0900202 Rev. 0
EOTec MX Multiplexer Models
MXB-MM2 / MXB-SM15
those MXB-SM40 / MXB-SM80
MX Base Modules

Installation Instructions

Original Instructions
and
Process
MX Multiplexer Base Modules
For use ONLY with the
EOTec MX Multiplexer Line
Nuclear Sensors &
Process Instrumentation