Precision AM60 Installation Manual

Precisi n
AM 6 O
MAGNETIC TUBULAR LATCH
1
Crossbore
o
1. Edgebore-Drill a 24mm hole into the edge of the door at
the desired height.
Crossbore-Drill hole(s) into the face of the door at a backset
of 60mm to the diameter(s) etc specified on the chosen
handles installation instructions.
4
4. Insert the plastic Strikebox/drilling template
edgebore hole and use as a guide to drill 2x
holes above and below edgebore hole.
Insert strikebox/drilling template into the
o
created in jamb (3a) and drill 2 x 3mm pilot holes above
o
and below 24mm hole.
INSTALLATION
Ezi - t housing cups
Strikebox/drilling template Strikebox/drilling template
Strikeplate Strikeplate
2
Edgebore
o
24mm
2. Insert the
(2A).
Close door tightly then press the pointed Strikemarker tool
into the jamb to mark a mounting position for the strikeplate.
5
o
into the
5. Use the 3mm pilot holes in door as a guide to drill
o
o
3mm pilot
2 x 24mm overlapping holes (above and below the
o
24mm hole) to a depth of approx. 5mm.
o
24mm hole
Repeat this step on the jamb to create 2 x overlapping
holes.
GUIDE
60mm
Self Adhesive Self Adhesive
coverplates coverplates
2a
Strikemarker tool (FIG.B) into the edgebore
edgebore
o
24mm
Precisi n
A M 6 O P V
TUBULAR PRIVACY BOLT
20mm 20mm
8x8mm 8x8mm
3
o
hole
3. Drill a 3mm pilot hole into the jamb at the position
marked by the pointed Strikemarker tool.
Use the pilot hole as a guide to drill a
the jamb to a depth of approx. 20mm.
6
6. Use a blade or pencil to mark vertical lines down the
sides of the 3x overlapping
jamb (6a).
Use a Chisel to remove timber from the sides of the
o
overlapping 24mm holes where marked.
3a
o
24mm hole into
6a
o
24mm holes on door and