Selecting A Location; Adjusting The Leveling Feet; Removing The Transit Bolts; Connecting The Water Supply Hose - Samsung WF-J1054 Owner's Instructions Manual

Samsung washing machine owner's instructions
Hide thumbs Also See for WF-J1054:
Table of Contents

Advertisement

Available languages

Available languages

Installing the Washing Machine

Selecting a location

Before you install the washing machine, select a location with the following characteristics:
A hard, level surface (if the surface is uneven, see "Adjusting the leveling feet, " below)
Away from direct sunlight.
Adequate ventilation
Room temperature that will not fall below 0 ˚C
Away from sources of heat such as coal or gas
Make sure that the washing machine does not stand on its power cord.
Ventilation openings must not be obstructed by carpeting when the washing machine is installed on a
carpeted floor.

Adjusting the leveling feet

If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under the feet):
1. Loosen the leg bolt by turning it with your hand until it is at the desired height.
2. Tighten the locking nut by turning it with the supplied wrench.
Place the washer on a sturdy, flat surface.
If the washer is placed on an uneven or weak surface, noise or vibration occurs.
(Only a l degree angle is allowed.)

Removing the transit bolts

Before using the washing machine, you must
remove the five transit bolts from the back of the
unit.
To remove the bolts:
1. Loosen all bolts with the supplied wrench before removing them.
2. Take each bolt head and plastic together, pull it through the wide part of the hole.
Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the transit bolts for future use.

Connecting the water supply hose

The water supply hose must be connected to the washing machine at one end and to the water faucet
at the other. Do not stretch the water supply hose. If the hose is too short and you do not wish to move
the water faucet, replace the hose with a longer, high pressure hose.
To connect the water supply hose:
1. Take the L-shaped arm fitting for the cold
water supply hose and connect to the cold
water supply intake on the back of the
machine. Tighten by hand.
Cotton
Remaining Time
Synthetic
Pre-wash
Delicate
12:00
o
C
Wash
rpm
Wool
Rinse
Power
Min
Speedy
START
Spin
PAUSE
Check
Delay Start
Eco
Fuzzy control
Door open
Temp
Spin
Delay Start
Function
SAMSUNG Washing Machine Owner's Instructions B-2

Advertisement

Table of Contents
loading

Table of Contents